My doors are not locking. I tested my immobilizer and it is not emitting a signal to the door locks. I directly power the door locks and they lock fine, so it is the immobilizer. It was wet and had some corrosion, but it wasnt bad. I cleaned as best I could, but it wont lock the doors. I get two beeps when I lock the door. It is immediately issuing a signal to unlock the doors.
- Locks work fine when I power the lock wire directly from the wiring diagram
- The central locking button does not work. It will light up with durametric light test though
- Only drivers door lock with key 3-lock turns
I get the following error codes on durametric:
- Code 60: Central locking limit position lock not reached
- Code 46: Central locking synchronization
- Yellow Code 47: Central locking synchronization
- Yellow Code 54: Radio receiver defective
What troubleshooting can I do?
Can I cut the wire for locking the door and somehow make it a manual door lock using a relay of some sort to send a lock signal to the locks?
I have 2001 Boxster S with M535 immobilizer, with antenna socket.
Threaded Mode
