Piston clip & camshaft tool

[El Vikingo Tropical]

What type of tool do you use or recommend for a amateur like mi, I just need one good enough to assemble two or three engines.
Is the “made in chine” ok for this?
https://www.ebay.co.uk/itm/174865022935

[Homeoboxter]

Originally Posted by El Vikingo Tropical

What type of tool do you use or recommend for a amateur like mi, I just need one good enough to assemble two or three engines.
Is the “made in chine” ok for this?
https://www.ebay.co.uk/itm/174865022935

I used one similar to this, worked perfectly.

[El Vikingo Tropical]

Originally Posted by Homeoboxter

I used one similar to this, worked perfectly.

Thanks for answering, I wasn’t sure if it’s works properly as I never used one!

[EMWynne]

I have 1 works OK...check the plastic bar for fitting the piston clips as there are 2 different sizes of piston pin...I had to have mine machined...all that,s missing from this kit is the piece of screwed rod to compress the vario cam tensioner... but you can make 1 yourself.