Factory rolled fenders...?

[particlewave]

No, I'm not sure

They measure 10" OD (edge to edge), but I'm sure they are 9's based on the part # (probably measured bead to bead, not actual width).

My fault...it was an off day. Took some Tylenol PM last night and have been really out of it all day

[RedTele58]

Originally Posted by particlewave

No, I'm not sure

PW - if the width and offset aren't cast into the front of the wheel on either side of the valve stem, they will be cast on one of the spokes on the back side of the wheel.

[mack73]

Originally Posted by particlewave

(probably measured bead to bead, not actual width).

Yes you measure width of the inside barrel which is 1" less than outside to outside

[healthservices]

Originally Posted by mack73

Yes you measure width of the inside barrel which is 1" less than outside to outside

Yes, the standard method of measurement is by the inside bead. if it was a steel wheel it would be less of a difference as steel wheels do not need to be made so thick.

[KRAM36]

Originally Posted by particlewave

No, I'm not sure

They measure 10" OD (edge to edge), but I'm sure they are 9's based on the part # (probably measured bead to bead, not actual width).

My fault...it was an off day. Took some Tylenol PM last night and have been really out of it all day

You had me freaking out with a Boxster coming with factory 10' rear wheels lol.