Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 05-19-2013, 05:04 PM   #541
Registered User
 
Porsche Chick's Avatar
 
Join Date: Jan 2013
Posts: 560
Awesome pics, Jager! Thanks for posting those.

I am starting to consider one of those old 356's . . .

__________________
2009 Porsche Boxster - Guards Red/Tan
Speed has never killed anyone, suddenly becoming stationary… that’s what gets you. – Jeremy Clarkson
Porsche Chick is offline   Reply With Quote
Old 05-19-2013, 09:28 PM   #542
Registered User
 
Join Date: Apr 2007
Location: Bay Area
Posts: 524
Did some waxing today. Two coats. Polish/Wax. Amazing how a black car comes out so much shinier than the white one.


__________________
2008 Boxster S PDE2
02 Boxster S Blk on Blk(Stock for the Wife)
88 turbo S (My Toy) slightly modified
cas951 is offline   Reply With Quote
Old 05-20-2013, 06:54 PM   #543
Registered User
 
Join Date: Apr 2013
Location: Buffalo NY
Posts: 184
Picked up my car from Ekston in Rochester.
-LN IMS
-RMS
-AOS
-Clutch and DMFW
-Oil change
-Coolant flush
-Nearly a box full of leaves and trash were removed from behind the radiators

Ate at Dinosaur BBQ and had a pretty amazing ride back to Buffalo with the top down.
cardiffgiant is offline   Reply With Quote
Old 05-21-2013, 07:09 AM   #544
Registered User
 
Coffinhunter's Avatar
 
Join Date: Jun 2012
Location: Hernando Beach, Florida
Posts: 444
Garage
Drove to work this morning. Now I get to look forward to driving home!!!! Love having her as my DD!
__________________
2003 Boxster S, 6-spd, Seal Grey/Grey top


Ka is a wheel, and everything is 19
Coffinhunter is offline   Reply With Quote
Old 05-21-2013, 12:19 PM   #545
Registered User
 
woodsman's Avatar
 
Join Date: Feb 2013
Location: Land of naught
Posts: 1,302
finished pulling the second rear suspension out. Everything seems solid so I handed them to a mechanic to install the new bearings- and wow are those some BEARINGS!! ( good value at $60 each @ Sunset). This is the turning point- now I only INSTALL- tranny, suspension, brakes and tires:dance: I WILL DRIVE THAT CAR AGAIN!! I MUST, I MUST ...
__________________
Death is certain, life is not.
woodsman is offline   Reply With Quote
Old 05-21-2013, 06:49 PM   #546
Registered User
 
Greybush's Avatar
 
Join Date: May 2013
Location: Sandy Eggo
Posts: 8
I changed out the amber side markers for the euro version.


[IMG][/IMG]
Greybush is offline   Reply With Quote
Old 05-21-2013, 07:41 PM   #547
Registered User
 
Join Date: Feb 2013
Location: 100 miles north of Sebring, Florida
Posts: 16
Garage
I removed the alternator. I feared the worst but it came out easier than I hoped....now I just wait for the replacement to arrive.
M1NDCRlME is offline   Reply With Quote
Old 05-22-2013, 06:14 AM   #548
Registered User
 
Join Date: Aug 2007
Location: NC
Posts: 7
Drove it to work

After 5 days of on and off rain, we finally get a nice warm, sunny day. So, I got to drive it to work! After 5 days of driving the minivan, it was a great feeling to get back behind the wheel of the 981 S.

tortoise944 is offline   Reply With Quote
Old 05-22-2013, 10:57 AM   #549
Registered User
 
woodsman's Avatar
 
Join Date: Feb 2013
Location: Land of naught
Posts: 1,302
what a beautiful car tortise944.
Dropped rear struts and disassembled-they're definitely newer than the front 2
__________________
Death is certain, life is not.
woodsman is offline   Reply With Quote
Old 05-22-2013, 07:05 PM   #550
Registered User
 
thom4782's Avatar
 
Join Date: Sep 2010
Location: Foster City CA
Posts: 1,099
Changed the oil today. I switched to Motul 5-40 from Mobil 1 0-30. . It may be a placebo like effect, but it seems to me that the engine is quieter on starts and while running. Anybody else had find the same?
thom4782 is offline   Reply With Quote
Old 05-22-2013, 07:28 PM   #551
Registered User
 
CoBeerToad's Avatar
 
Join Date: Jun 2012
Location: Peoria IL
Posts: 529
Garage
Finally replaced the pin that connects to the rod that controls the convertible top. What a pain, but I feel better having both rods now and not having to guide one side up or down.
CoBeerToad is offline   Reply With Quote
Old 05-26-2013, 01:40 AM   #552
Registered User
 
Spinnaker's Avatar
 
Join Date: Dec 2007
Location: Seattle
Posts: 735
Flushed the brake fluid and changed out the rear pads. Caught it just in time, one pad was worn down to where the wear sensor was just starting to get rubbed on.
__________________
2000S Ocean Blue Metallic- 116K
3X Water Pump, Clear side markers, Crios Mod, Front engine mount, Flywheel, clutch, RMS, AOS, MAF, serpentine belt, power brake vacuum line, battery, 2X CV boots, Fuel filter, Oil filler tube, 3X ignition switch, 90K service, gas cap, Coolant tank
Spinnaker is offline   Reply With Quote
Old 05-26-2013, 09:07 AM   #553
Registered User
 
greenheckler's Avatar
 
Join Date: Jan 2012
Location: Orange County, CA
Posts: 68
Wink

Painted my nuts and cleaned the areas in between.

BEFORE:


AFTER
__________________
2001 Boxster Guards Red
greenheckler is offline   Reply With Quote
Old 05-26-2013, 11:02 AM   #554
Registered User
 
woodsman's Avatar
 
Join Date: Feb 2013
Location: Land of naught
Posts: 1,302
Thought I'd be smart and put the incredibly expensive (Porsche, of course!) oil in my trans BEFORE installing and found that it no longer pivots nicely on the spear like thing on the underside now. I'm using just a floorjack to raise it into position and removed the jack pad and sat that spear right in the hole! Worked like a charm pulling it out but need a counterbalancing mechanic's wire arrangement going in. Then I noticed that the release bearing pops out of the arm too easily- the inner sides where the bearing clips into are worn by about 0.01" on each side-oh no!!! I ordered a new one and it'll take about a week to get it! (Porsche, of course!) My Toyota's have a spring-steel clip the size of my thumb on either side of the bearing support and are 100 times stronger and weigh just a few ounces more. 0.010" of wear shouldn't matter and can be the differeince between reliable and not- in a Porsche!!! Marvel of engineering that...
__________________
Death is certain, life is not.
woodsman is offline   Reply With Quote
Old 05-26-2013, 12:12 PM   #555
Registered User
 
BYprodriver's Avatar
 
Join Date: Oct 2008
Location: O.C. CA
Posts: 3,709
Garage
Drove my Box out to CA Speedway to the Porsche Roadshow event.

Got to drive the 2014 Cayman S & 991 4S on the infield course up to 100 mph!
Both these cars are so smooth & ride very nice!
BYprodriver is offline   Reply With Quote
Old 05-26-2013, 03:16 PM   #556
Registered User
 
Izman1000's Avatar
 
Join Date: Mar 2013
Location: New Jersey, USA
Posts: 95
Drove to the Jersey shore to check our rental property for this summer's vacation. An hour and fifteen minutes each way all by myself with some quality alone time down at the beach. I hit 120 MPH a few times on the ride and had some fun. With brand new Michelins put on a few weeks ago, the ride was awesome!
Izman1000 is offline   Reply With Quote
Old 05-26-2013, 03:43 PM   #557
Registered User
 
Join Date: Apr 2013
Location: Buffalo NY
Posts: 184
Washed, replaced cabin air filter, replaced gas cap, and cleaned the drain holes. The fronts were really bad, completely clogged with dirt.

Then we took it out for a spirited drive with the top down What a blast!!
cardiffgiant is offline   Reply With Quote
Old 05-27-2013, 02:16 PM   #558
Registered User
 
Join Date: Apr 2011
Location: California
Posts: 236
Bought this for the boxster today...



Now off to the paint shop to get it color matched!
Appleguy is offline   Reply With Quote
Old 05-27-2013, 03:16 PM   #559
Registered User
 
Join Date: Jun 2011
Location: oklahoma
Posts: 27
Put new tires on the Boxster and gave the GTO an oil and filter change. The Boxster is ready for weekend fun on the twisty's and Big Red is all set for the summer Rod Runs and burning a little rubber!

sailing1 is offline   Reply With Quote
Old 05-27-2013, 04:01 PM   #560
Registered User
 
Join Date: Apr 2011
Location: California
Posts: 236
Quote:
Originally Posted by Appleguy View Post
Bought this for the boxster today...



Now off to the paint shop to get it color matched!
Update...

NOW it's ready for the paint shop

Appleguy is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 08:56 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page