replace wheel bearing or hub assembly?

[magnusk9]

Wow that is even better.... looks like with the price of the tool and bearings I could just do it myself... I always heard removing the bearing was a nightmare.

Looks like I will be ordering parts and tools.

[magnusk9]

have you ever used that bearing puller before? Wonder how it works compared to the boxster specific one or even a generic one?

[Bala]

I just did all four bearings and can tell you that none of the auto store tools can do what the SIR tol does. I broke down and bought it after three days of struggling.The rear bearings are not that hard. However i was removing the entire suspension, axles etc so might have been easier for me than doing it on the vehicle. But cant imagine it would be too difficult. I would recommend you do the axle boot, grease while you are doing this.

I'm dome with the tool but dont plan to sell it. I can loan it to you if you want to use it. Pay a deposit for the tool, pay shipping back and forth and some beer money so I can go to the post office on the way to the beer store.

It is the full kit for the older version Boxsters so it will fit your hub. PM me if interested.

[magnusk9]

So I started doing the bearing today.... I bought the bearing removal tool but half way through I realized it did not have the hub extractor like the one below



.


I have one question.....How do you get the axle out from behind? They kind of glance over it in the tech article

[Bala]

If you are doing the rear you need the hub extractor. I was able to do the front without though it took me a couple days of trial and improvisation.

If you need the hub extractor let me know.

As for removing the axle, I removed the 6 bolts that connect it to the tranny, loosened the axle nut (wheel) until it was flush with the outer end used a small piece of wood as buffer and tapped softly with a rubber mallet. Watch the axle as it will probably be resting on the exhaust and it's heavy.