Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 10-31-2011, 04:59 PM   #1
2001 RUF 3800S
 
violametallic-S-'s Avatar
 
Join Date: Mar 2009
Location: Ontario, Canada
Posts: 326
Chunky Brown Sludge in Coolant Tank...

I thought my coolant was low because on the gauge it showed 1/3 full but when i started to fill up brown crap came out of it right away.

First picture show what came out when I initially filled up

Second picture shows the bottom after taking out the coolant

Third shows in the inside wall with the brown gunk caked on

Fill it up with water and sucked it out a few times and the brown crap didnt come off the walls.

As for the last picture it shows new coolant added after "cleaning"

I did research on here and I fear the worse then just a "oil cooler"

How screwed am I?

Attached Images
       
__________________
IG: RUF3800S

Last edited by violametallic-S-; 10-31-2011 at 05:03 PM.
violametallic-S- is offline   Reply With Quote
Old 10-31-2011, 05:28 PM   #2
Track rat
 
Topless's Avatar
 
Join Date: Nov 2006
Location: Southern ID
Posts: 3,701
Garage
Nasty coolant is never a good sign. Pull your dip stick and see what it looks like. If you have a chocolate milkshake there too, you have lost $$$ in your future. Good luck with your investigation.
__________________
2009 Cayman 2.9L PDK (with a few tweaks)
PCA-GPX Chief Driving Instructor-Ret.
Topless is offline   Reply With Quote
Old 10-31-2011, 05:30 PM   #3
Registered User
 
Join Date: Jul 2009
Location: Kansas
Posts: 83
I would start with removing oil cooler and taking it to a radiator shop to have it pressure-tested. They will be able to instantly tell you if it has a leak or not.
Good luck
__________________
1983 928 S Euro- fun to work on
2002 Boxster- fun to work on, being able to drive it is a bonus
al83s is offline   Reply With Quote
Old 10-31-2011, 05:39 PM   #4
Registered User
 
Join Date: Oct 2011
Location: San Diego
Posts: 111
Oh boy, that is UGLY.

Oil in coolant = bad.
ChairmanRon is offline   Reply With Quote
Old 10-31-2011, 06:06 PM   #5
Registered User
 
Join Date: Oct 2011
Location: Olympia, Wa
Posts: 370
my 944 I had coolant looked like that, it was the oil cooler/oil cooler seals
fivepointnine is offline   Reply With Quote
Old 10-31-2011, 06:57 PM   #6
2001 RUF 3800S
 
violametallic-S-'s Avatar
 
Join Date: Mar 2009
Location: Ontario, Canada
Posts: 326
I hope it is the cooler. But have I done any engine damage?
__________________
IG: RUF3800S
violametallic-S- is offline   Reply With Quote
Old 10-31-2011, 08:21 PM   #7
Registered User
 
Join Date: Dec 2009
Location: Orange County, CA
Posts: 1,919
Quote:
Originally Posted by violametallic-S- View Post
I hope it is the cooler. But have I done any engine damage?
violametallic...

If your engine is not overheating or puffing white smoke and running smooth you probably will be ok.

Once you replace the oil cooler you may want to fill it up only with water, run the engine, drain fill up again, run the engine, drain, etc, etc, until the water comes clean, then fill it again with destilled water and the proper antifreeze mix.

Think optimistic.. :-)

.
Gilles is online now   Reply With Quote
Old 10-31-2011, 09:29 PM   #8
2001 RUF 3800S
 
violametallic-S-'s Avatar
 
Join Date: Mar 2009
Location: Ontario, Canada
Posts: 326
Thanks Gilles, engine is running well no over heating or smoke.

im hoping for the best
__________________
IG: RUF3800S
violametallic-S- is offline   Reply With Quote
Old 10-31-2011, 09:51 PM   #9
Registered User
 
Join Date: Oct 2011
Location: Olympia, Wa
Posts: 370
yeah they had to flush the oil and coolant a couple times in my 944 to get rid of all the goop
fivepointnine is offline   Reply With Quote
Old 11-01-2011, 06:34 AM   #10
Registered User
 
Join Date: Dec 2010
Location: Hot Springs Village, Arkansas
Posts: 245
I've heard of folks using Dawn dishwashing detergent to get rid of oil contamination in the oil system. You'll be an expert in the art of flushing and air venting by the time you're done. The O-ring seals on the oil cooler might be the source if you're lucky. Hate to think it's a head gasket.
Dale_K is offline   Reply With Quote
Old 11-01-2011, 11:19 AM   #11
Registered User
 
Join Date: May 2011
Location: Miami florida
Posts: 1,591
Quote:
Originally Posted by violametallic-S- View Post
Thanks Gilles, engine is running well no over heating or smoke.

im hoping for the best
Don't drive the car in this condition. I wouldn't even start it. Drain the oil, if there is no water or "milkshake" in it, then there's a good chance its just a failed oil cooler.
__________________
Current car

2000 Boxster 2.7l red/black

Previous cars

1973 Opel Manta
1969(?) Fiat 850 Convertible
1979 Lancia Beta Coupe
1981 Alfa Romeo GTV 6
1985 Alfa Romeo Graduate
1985 Porsche 944
1989 Porsche 944
1981 Triumph TR7
1989 (?) Alfa Romeo Milano
1993 Saab 9000
san rensho is offline   Reply With Quote
Old 11-01-2011, 11:50 AM   #12
Registered User
 
Join Date: Dec 2009
Location: Orange County, CA
Posts: 1,919
Quote:
Originally Posted by Dale_K View Post
I've heard of folks using Dawn dishwashing detergent to get rid of oil contamination in the oil system. You'll be an expert in the art of flushing and air venting by the time you're done. The O-ring seals on the oil cooler might be the source if you're lucky. Hate to think it's a head gasket.
Violametallic,

I would not use soap...

Actually Prestone has a product called "cooling system flush or radiator flush" that you add to the cooling system and let the engine run for a while to clean all the passages and radiators (open the heater valve)

However, this is an agresive chemical (for prolonged contact with aluminum) that must be neutralized (by another Prestone product) and afterwards to will want to flush several times until your water comes off clean.

It will take you most of the day because every time you add coolant you want the thermostat to be fully open, the good part is that both of the Prestone products will cost you a little over $10 ...

again, good luck!

.
Gilles is online now   Reply With Quote
Old 11-01-2011, 08:10 PM   #13
Registered User
 
Jager's Avatar
 
Join Date: Jul 2010
Location: California
Posts: 1,859
Garage
Not likely to be the oil cooler but the oil cooler seals... They need to be replaced once in awhile. See photo of what happens to them over time (they break-down and crumble).
Attached Images
 
__________________
Jäger

300K Mile Club
Jager is online now   Reply With Quote
Old 11-04-2011, 05:50 AM   #14
2001 RUF 3800S
 
violametallic-S-'s Avatar
 
Join Date: Mar 2009
Location: Ontario, Canada
Posts: 326
is this something I can fix on my own?
__________________
IG: RUF3800S
violametallic-S- is offline   Reply With Quote
Old 11-04-2011, 05:57 AM   #15
Registered User
 
Spinnaker's Avatar
 
Join Date: Dec 2007
Location: Seattle
Posts: 735
Look at figure 7 in this DIY.
Pelican Technical Article: Boxster Starter Replacement - 986 / 987
__________________
2000S Ocean Blue Metallic- 116K
3X Water Pump, Clear side markers, Crios Mod, Front engine mount, Flywheel, clutch, RMS, AOS, MAF, serpentine belt, power brake vacuum line, battery, 2X CV boots, Fuel filter, Oil filler tube, 3X ignition switch, 90K service, gas cap, Coolant tank
Spinnaker is offline   Reply With Quote
Old 11-05-2011, 06:06 PM   #16
Matt
 
MileHighBoxster's Avatar
 
Join Date: Nov 2011
Location: Colorado
Posts: 284
Man that's ugly. Let us know what your dealer says is the problem.
MileHighBoxster is offline   Reply With Quote
Old 11-10-2011, 12:38 PM   #17
2001 RUF 3800S
 
violametallic-S-'s Avatar
 
Join Date: Mar 2009
Location: Ontario, Canada
Posts: 326
How much would an oil cooler cost me? and where to look?
__________________
IG: RUF3800S
violametallic-S- is offline   Reply With Quote
Old 11-10-2011, 01:13 PM   #18
Registered User
 
Join Date: Feb 2005
Location: It's a kind of magic.....
Posts: 6,482
About $200 or so from Sunset Porsche. Be sure to replace all the orings or you will have leaks.....
__________________
Anything really new is invented only in one’s youth. Later, one becomes more experienced, more famous – and more stupid.” - Albert Einstein
JFP in PA is online now   Reply With Quote
Old 11-10-2011, 01:31 PM   #19
Matt
 
MileHighBoxster's Avatar
 
Join Date: Nov 2011
Location: Colorado
Posts: 284
Quote:
Originally Posted by violametallic-S- View Post
How much would an oil cooler cost me? and where to look?
I get all my parts from the dealership........... where they are installed. No grease under these nails.
MileHighBoxster is offline   Reply With Quote
Old 11-10-2011, 03:36 PM   #20
Registered User
 
John99Boxster's Avatar
 
Join Date: Oct 2011
Location: Wilmington, NC
Posts: 229
Garage
Quote:
Originally Posted by MileHighBoxster View Post
I get all my parts from the dealership........... where they are installed. No grease under these nails.

No Grease under your nails....hmmm.....good for you and your wallet!

wow!:ah:

John99Boxster is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 02:05 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page