Hardtop Question: Installation

[ekimfunk]

I jsut installed the spinlocks and bolts for a hardtop installation on my 97 Boxster (black/red). I tried the "baggie" trick, but it seemed that the baggies were too fragile; i.e. my tests had the hex tool penetrating the baggie with any force...so I used the old stand in....DUCT TAPE!!! I cut a little "x" in the center of a 16" long strip of duct tape, inserted the bolt into it (from the sticky side, them hooked on my 5mm T handle tool, and ran the tape onto the shaft of the tool. The bolt will never come off with this setup. I ran the bolt in, tightened it, then "ripped" the tool out, along with most of the duct tape. There was a little duct tape around the head of the bolyts, I simply trimmed it off with an exacto knife.