Key learning code

[silverredboxster]

Hi,
I finally bought the control unit from sunset. When I compared it to the old one, I found out there is a 15 A fuse on the new one but it is missing on the old one. I then intalled a 15A fuse to the old unit and now the car starts, alarm works and door lock works. The only thing not working now is the windows. I checked power and ground and both are good. What else can I check? Any suggestions?

Thanks

Jon

[tamarsha]

I had my driver side window stop working on me a while back while I was messing with the radio. After looking through the manual and on-line I disconnected the battery, waited a few, and hooked it back up. I was then able to run the window down and back up so it would relearn the up and down positions. I had to do this twice because I didn’t do the “on touch” up and down with the door closed.

Why the window stopped working in the first place I do not know. I must have been leaning on the switch or something.

[silverredboxster]

Hi,

I fixed the windows too.. Both power wires were corroded inside the front door grommets causing open cirucits.. Now everything works.. But I don't think i can return the alarm ECU even though i didn't even install it.. Thanks for all ur help.

Jon