Clear Armor?

[Frank Patrick]

I had it applied ( hood&mirrors) on my 02. Excellent results. Lots of highway miles and virtually "chip" free. I'd do it again.

[CJ_Boxster]

After my car is done in the paint shop, Im having it done for free because it's being done for a car magazine story by Marshall Spiegel. Hes the photographer, He used to race in nascar professionally as well as Rally. Lucky me!

[z12358]

Do a "clear bra" search. There were a lot of discussions here on the subject.
I had the clear bra installed on my Box right after I bought it last year. Can't remember but it was around $1100 for bumper, full hood, lights, full front fenders, installed. Cheaper for part-hood, part-fenders. Had it for a year now and am very satisfied. It's invisible and people only notice it when I show them the two 3" edges at the end of the hood under the windshield. There are no other visible edges. One note though, the installer chose Avery's film (instead of 3M) for my black Box -- apparently doesn't yellow with time and has the same finish consistency as the original paint, thus making it indistinguishable from the 'naked' panels . So far, he's been proven right.

Just in case anyone thinks it's a DYI. The bumper is a 5/5 difficulty installation. Took him two attempts and 6 hours to line up all the bumper lines right. And he does all the Ferraris and Lambos from the local dealers, and is considered to be one of the best in the area. Perhaps it can be done cheaper but there are hack jobs that just cut and plaster pieces one next to another with edges galore.
Z.

[fab]

I just picked up my car from the autobody shop last night. I had Autobahnd applied for $595. This includes the hood, front bumper, 2 mirrors LT/RT side fender. And they also applied a strip right after the front tires.
I really haven't had a chance to take a REAL good look it's been raining.
http://www.myautobahnd.com/

[z12358]

fab, did you apply the cover over fresh paint? I think my installer told me that 1-3 (I don't remember) months of paint curing is necessary before the cover installation.
Z.

[blue2000s]

Originally Posted by z12358

fab, did you apply the cover over fresh paint? I think my installer told me that 1-3 (I don't remember) months of paint curing is necessary before the cover installation.
Z.

That depends on the paint application. Air dry will need some curing time. Baked paint needs almost none.

[John V]

The films are porous. They can be applied to paint that is not fully cured.

The Boxster is one of the most difficult cars to cover. I have a friend who did mine free (he has done a few other very difficult cars) and it turned out great, but I would not suggest anyone try it themselves unless they're willing to ruin a lot of film attempting it.

[blue2000s]

Originally Posted by John V

The films are porous. They can be applied to paint that is not fully cured.
.

You also have to consider what the curing from the paint will do to the plastic. I'd wait for a cured surface.

[z12358]

Originally Posted by John V

The films are porous. They can be applied to paint that is not fully cured.

John, I'm no expert but this doesn't make sense. I can imagine this would bake (cure) the film into the paint thus making it impossible to remove without taking the paint with it.
Z.

[n4ally2]

Thanks for the info. Where do you suggest that I have it done? Should I take it back to the dealership or have it done at a specialized autoshop? I assume that the dealership would cost me more. What do you think?