Parting '97 Boxster Black

[nimblemotorsports]

Originally Posted by trj

how about a key, immobilizer and ecu?

Have a key and the immoblizer, but no ecu, so I gather that doesn't help, sorry.

Would you like a rear stablizer, or some front fenders, or how about a convertible top?

[nimblemotorsports]

I'm getting ready to haul this car off to the crusher, so I'm wondering if there are parts that i should remove that are not obviously of value. Like the brake booster and brake master cylinder, the A/C components, the heater tubes, gas tank, that kind of stuff.
Without buyers (and hey gots lots of stuff still), it will just add to my junk collection, and I need to get rid of all my junk!

[PorscheFan5]

Jack,

I wish you were close by, I could pass-by and look to take what I needed...

Did you get rid of the engine? I was thinking of the pulleys...I have to fit my A/C in my conversion and am thinking of fitting a pulley at the back of the Warp 9 and making a metal bracket to fit the A/C unit using a belt...

Just a thought...since the pulleys will be at least the same width as the A/C pulley...

[pony13ca]

Do you still have the Horseshoe bezel for the Radio? How much shipped to Toronto?

[nimblemotorsports]

Originally Posted by pony13ca

Do you still have the Horseshoe bezel for the Radio? How much shipped to Toronto?

Still have it I think, $30 should do it.

[pony13ca]

Originally Posted by nimblemotorsports

Still have it I think, $30 should do it.

$30 shipped? I'll take it!! Let me know what's next.

[nimblemotorsports]

Originally Posted by pony13ca

$30 shipped? I'll take it!! Let me know what's next.

Send me a PM with your address and paypal the funds.
But let's first make sure I know what the horseshoe bezel is for the radio.
Is it the thing that the radio fits inside, with the vents on top?

[nimblemotorsports]

Originally Posted by PorscheFan5

Jack,

I wish you were close by, I could pass-by and look to take what I needed...

Did you get rid of the engine? I was thinking of the pulleys...I have to fit my A/C in my conversion and am thinking of fitting a pulley at the back of the Warp 9 and making a metal bracket to fit the A/C unit using a belt...

Just a thought...since the pulleys will be at least the same width as the A/C pulley...

Never had an engine, sorry.