Center console rear compartment lid
 

Woody, I've searched your FB page as well as here and Mr Flat Six and I are in need of the same piece, his is gray and I require black. Any chance you have the lid, or even the entire center covering, for a 2000 S?

Cheers.
:cheers:

WTB -Passenger Side Rear mudflat
 

Looking for the passenger side rear mudflat which is in front of rear tire. Lmk if you have one and how much shipped to zip 10312


Thanks

I'm assuming that was you who asked the same question on my FB page? If not, Pelican sells a cheap repair kit for a broken hinge.

Those for some reason are always broken, along with the last plastic belly pan.

All good
 

Woody, yes that was me. I appreciate your response. I will keep trying to fix that lid.
Thanks again.
Thom

986 rear trim
 

Looking for the rear trim piece in front of rear wheels. Similar to a mudflap, only in front of each wheel on a 986S. Both sides.
9865043930001C & 9865043940001C oe numbers
Also a headlight switch assembly. Mine is having dash light issues.

Thanks

Those for some reason are always broken, along with the last plastic belly pan. I sell the light switch for $60 shipped. You can text me at 512-925-9171 if you're interested....Thanks Woody

People must be launching curbs or driveways. Mine was fine for 15 years!
Thanks for checking.

Throttle Body Connector
 

I am looking for the six pin connector to the Throttle Body and a pigtail of 12" from a 2005 Boxster S your help would be deeply appreciated.

Thanks
Gerd
use email gerdbamesberger@gmail.com

I need a wind screen (plastic mesh) driver side roll bar, '99 base boxster. Thanks!

Sorry guys but I don't have either

Silver 1999 Boxster front or rear bumper needed
 

Looking for a front or rear bumper to hang on my shop wall. Do you have anything? Some dents are okay.

Sorry I don't have any and I don't ship large body parts if I did.

Hey Woody. Do you have a driver's side air vent?

Yes for $25+shipping. 97-99 or 2000-04? It's always best to text me at 512-925-9171
Thanks Woody

Fourth stalk for OBC
 

Hi Woody,

I'm interested in adding a fourth stalk to my steering column to enable OBC interaction. Would you have one that's in good condition?

Joe

I know I have some for the early boxsters but I'm not sure if I have one for the later cars. I'll check tomorrow. $100+shipping and I try to include the wire harness connectors to the stalk and cluster.

Woody I'm looking for a rear 986S bumper. Also for a driver's seat in tan and the left side smoked cover for the interior light by the mirror.

Sent from my SM-G955U using Tapatalk

Looking for a rear 986S bumper. Any color. Drivers seat in tan? Smoked piece that covers interior light by mirror. Left side. 4th stalk. Thanks!

Sent from my SM-G955U using Tapatalk

Woody, would you by any chance have a complete set of wind deflectors for a 2001 Boxster S? New prices are just obscene so I'm hoping to find some good to great condition used ones.

Hi Robert, It's best to follow my facebook page "Woody's Parts LLC" and call dibs when any come in. I get asked about those almost every day. When I get some in they usually sell within hours if not minutes. I wish I could tell you I would save a pair for you but that would be unfair to all the other people who asked before you. A little heads up though. I'm suspecting that I'll be getting a lot more inventory over the next 1-5 months.

Hi Woody! Hopefully you are surviving hurricane season. Would you have a low mileage right axle for a 99? The right inner CV joint bit the dust the other day. Not going to pay $800 for a new one. Thought about buying a new CV joint from Pelican and putting it on $80. Not sure how difficult that would be. Do you have any advice experience with this?

I don't have any manual or S axles as the spec or WRL guys buy all those. I have a few base tiptronic axles for $50+shipping each. I'd recommend going with the pelican joint if your outer joint is good. It's a real easy fix. Messy but easy

Woody; I'm thinking about converting my 98 to the later model top transmissions. I'd need the transmissions and the standoff bolts. Got any low mileage ones available?

I sell the transmissions for $50 each but they're all a crap shoot at this point. I'd throw in the bolts for free. Why do you want to switch?

Mine are getting a bit jerky about halfway back, and I like the smoothness of the later transmissions. Just drove an 02 and night and day diff.

Woody do you have any rear bumper screws for a 986 01 S?

Hi,
I'm sure I have one and that's something I would throw in for free if you were ordering something more significant. Otherwise my minimum is $20 shipped.
Thanks Woody

Drivers door latch for an 03 base?

Also frunk latch?

I sell the door mechanism for $50 and the front latch for $20 plus shipping

Sounds good to me. Do you mind shipping them next day air?

Pm sent

Sure but that can be stupid expensive. Please text me at 512-925-9171 so I can send you pictures. Thx

Hi,

looking for a few things if you have them, going in an 01 Boxster S...

Passenger door lock mechanism, window regulator, micro switches
Drivers window regulator and microswitches
Charcoal canister
6 speed shifter boot
oem SSK
clean black center console

shipped to 23220

Thanks!

Hi
I'm looking for 2 front lower control arms for an 02 Boxster Base Standard Suspension.
The lower the mileage and the better the condition, the better.
Shipped to 90717
thanks!

The lowest I have has 55K on them. $40+shipping for the pair. Unless you're in a bind, I wouldn't suggest buying them.

I'm a noob to Pcars.....should I only install new ones?

tan seats?
 

Looking for a pair in good shape, no repairs needed, for an 03 base. Los Angeles.

I would if I were you. I'd also suggest replacing the control arm links too.

Sorry I don't have any

Thanks for that, Woody.

Hey Woody, noobie here. Appears that the previous owner might've not gotten frunk latched properly and had what I can only imagine as 5 seconds of terror. Windshield has obviously been replaced judging by the poor job of fitting the molding trim and gas shock tops damaged. Anyway, hood I have is reworkable but dented at the windshield edge. Looking for a black bolt in and go replacement for an 01 shipped to Iowa.

Woody I'm hoping you can help me out... Last night I put my key in the door lock and turned it, the door unlocked but the key would not turn back to center or come out. So I spent my Sunday evening in the parking lot of Wal-Mart taking off my door panel and removing the lock assembly. When I got it out it pretty much fell apart.

Attachment 21120
Attachment 21121

I'm pretty sure I need everything but the tumbler to fix this and a doorlock itself as my actuator stopped working a while ago.

98 Boxster Base

Thanks in advance.