Quote:
Originally Posted by LoneWolfGal
Wish you were here, because the IMS Solution's installation instructions made my hair stand on end. For example, by drilling and sawing, "cut a notch in the crank case for the pressurized oil line that feeds the IMS Solution." Yikes!
|
It really isn't all that bad; you need to set the Solution flange loosely in place, mark the line fitting location with a marker on the bellhousing flange, then using a couple of increasing drill sizes, drill out where the fitting will sit, then use a metal saw to saw into the final hole you drilled out. A little bit of filing to break all the sharp edges from the drill and cutting and presto, a perfect slot for the flange's fittling to drop into, the slot being a little large is fine. Only takes a few min. to do.