View Single Post
Old 07-19-2020, 02:03 AM   #61
GLImages
Newbie
 
Join Date: May 2019
Location: Atlanta Area
Posts: 95
Garage
You can spray the plexi with ice water if it starts to melt or overheat when your cutting. Keeping it cool helps keep the blade clear of melted acrylic. I found higher speed worked better (i was using a dremel). I left the wax paper on last time (helps stop scratches while your sliding it around to cut it.) I also tape the edge where I'm cutting.

Sent from my SM-G965U using Tapatalk
__________________
1998 Porsche Boxster Base - 2005 Volvo S60R AWD - 2003 Subaru Wrx Wagon - 2003 Jeep Wrangler Rubicon - 1992 Subaru Loyale Wagon w/4in Lift - 2004 Dodge Ram 2500
GLImages is offline   Reply With Quote