View Single Post
Old 09-29-2018, 02:12 PM   #87
P_Carfahrer
Pathological Tinkerer
 
Join Date: Mar 2017
Location: Utah
Posts: 197
I successfully changed our my cluster leds. Broke one stepper motor shaft and had to solder a new motor on the board. Hardest part was positing needles. I couldn’t get it right until I plugged the cluster in without the lenses and the needles not completely pressed in and verified data with my scanners and then matched the positions and pressed them in.

Thanks Charles.



P_Carfahrer is offline   Reply With Quote