[drewmarc]

So as I was replacing my slave cylinder using the 101 project guide, I actually had the cast iron slave cylinder rather than the plastic one. Consequently, I have a different hydraulic line than shown in any pictures. I had to do a lot of digging on the internet to find anyone that had done something similar. I have attached pictures of the cylinder as well as a link to the other post on this forum that featured a similar issue. I cant seem to figure out how to detach the line from the current slave cylinder as it is not the plastic ring with a metal hook you can just pull out. You can see in the pictures where the bleed nipple is, and attached is still the line. Any help would be appreciated!

I also attached a picture of the new plastic one I purchased