[KevinH1990]

Originally Posted by oldskool73

Wired it up successfully.

Cut the 3 pin connector off an small stepper motor in an Arduino kit I had lying around and it fitted over the new lights pins fine. Attached the other ends of the wires to small spades and pushed them into the old connector slots instead of hacking it off, in case I ever want to go back.

They have swapped the wire order around just to keep us on our toes:

old ---> new
left (door open power) ---> left
middle (ground) ---> right
right (constant power) ---> middle

The led also works, but really... what's the point, that thing hardly illuminates the rear view mirror, let alone anything in the cabin!

Thanks all for your help.

Do you think this connector will work?
Molex 3-Pin Connector Kit 0.093" 3 Sets

I've asked the seller to see if they can include the connector from the car, but I'd like to have a back up plan if they can't help me. A few years ago I would have taken the part to Radio Shack and found something, but they have closed most of the stores in my area and there aren't any close to me.