Quote:
Originally Posted by amagalla
Yes. Using Durametric. I wrote the numbers down, but I can't find the sheet right now. It was only a few degrees. Neither bank went passed -3. When I say not at TDC, it's REALLY REALLY close. It's off just enough to not let the locking tool slip into the boss. Using a mirror I can see the hole in the boss through the hole in the main pulley, but it's slightly off.
|
3 degrees isn't close, its a mile...
__________________
Jake Raby/www.flat6innovations.com
IMS Solution/ Faultless Tool Inventor
US Patent 8,992,089 &
US Patent 9,416,697
Developer of The IMS Retrofit Procedure- M96/ M97 Specialist
|