986 Forum - The Community for Porsche Boxster & Cayman Owners - View Single Post

antny · 03-02-2015, 12:12 PM

Thank bud. I just need the piston since mine is stuck solid. To answer Jim's question about the cupholders. It will only fit in the slot where the original HVAC controls went. The HVAC controls will have to go into the bottom most slot closest to the shifter. The support plastic pieces only have slots to screw those in in the original slot and the bottom slot. I just did the relocation not too long ago. I wished these would have been for sale just a month ago. I paid over 100 for the cupholders new then I had to buy the trim piece for the lower HVAC controls.

Do you have a HVAC control panel that works 100% I have some dead pixels which I think it is causing my vent controls not to work 100%. My center vents are always blowing no matter what setting it is on.

03-02-2015, 12:12 PM	#12
antny Registered User Join Date: Nov 2014 Location: Oklahoma Posts: 246	Thank bud. I just need the piston since mine is stuck solid. To answer Jim's question about the cupholders. It will only fit in the slot where the original HVAC controls went. The HVAC controls will have to go into the bottom most slot closest to the shifter. The support plastic pieces only have slots to screw those in in the original slot and the bottom slot. I just did the relocation not too long ago. I wished these would have been for sale just a month ago. I paid over 100 for the cupholders new then I had to buy the trim piece for the lower HVAC controls. Do you have a HVAC control panel that works 100% I have some dead pixels which I think it is causing my vent controls not to work 100%. My center vents are always blowing no matter what setting it is on. Last edited by antny; 03-02-2015 at 12:14 PM.