Well I went through the process and here are the results. It was a lot of work. Scrubbing, buffing, sanding to get the old surface prepped and ready to accept the paint. I went with the G2 kit. Followed the instructions to the letter, and made every attempt to be careful and thorough. Also went with the Ebay decals. My honest impression overall: not exactly blown away. They will look good from a distance, especially against the backdrop of a new set of rotors, but up close the brush strokes are clearly visible, and the paint didn't "lie down" to the extent advertised. I even went with a sponge brush for the final coat to ensure smoother finish. Also, the decal adhesive is clearly visible beneath the printing. Again, after following the instructions to the letter. If I had to do it over again, I think I'd go with stencils. Don't think I'd go with powder coating as I've heard too many opinions to the contrary.