View Single Post
Old 07-22-2012, 03:17 PM   #6
Spinnaker
Registered User
 
Spinnaker's Avatar
 
Join Date: Dec 2007
Location: Seattle
Posts: 735
Are you any good with a volt meter? You need to determine if there is any voltage at the bulbs. If not, then you need to start tracing back through the circuit to find the fault. Check the grounds also.
Just a guess, but maybe when you swapped out to the LED's, you may have bent a pin in a connector or broken a wire. Happens all the time.
__________________
2000S Ocean Blue Metallic- 116K
3X Water Pump, Clear side markers, Crios Mod, Front engine mount, Flywheel, clutch, RMS, AOS, MAF, serpentine belt, power brake vacuum line, battery, 2X CV boots, Fuel filter, Oil filler tube, 3X ignition switch, 90K service, gas cap

Last edited by Spinnaker; 07-24-2012 at 04:08 PM.
Spinnaker is offline   Reply With Quote