986 Forum - The Community for Porsche Boxster & Cayman Owners

		986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums
Search Results

Garage

Page 2 of 2

Showing results 26 to 44 of 44
Search took 0.01 seconds; generated 26 minute(s) ago. Search: Posts Made By: since95

Forum: Boxster General Discussions

05-30-2018, 11:25 AM

Replies: 10

rebuild or replace engine?

Views: 6,280

Posted By since95

rebuild or replace engine?

Spun a rod bearing on a 2000 S while on the track last week. damage turned out to be rather minimal, limited to one crank journal and the single rod. Race engine builder told me crank would be...

Forum: Boxster General Discussions

05-30-2018, 10:02 AM

Replies: 16

Hardtop shoulder bolts

Views: 1,494

Posted By since95

Too funny! did mine this spring said the same...

Too funny! did mine this spring said the same thing, just didn't post it!

Forum: Performance and Technical Chat

05-15-2018, 11:05 AM

Replies: 1

Fuel smell occasionally strong

Views: 2,422

Posted By since95

Just went through the fuel smell thing. you are...

Just went through the fuel smell thing. you are getting an evap error where I did not. Mine turned out simple, although it was the last place I looked - gas cap seal was deteriorated and partially...

Forum: Performance and Technical Chat

05-11-2018, 06:58 AM

Replies: 0

2000 S suspension upgrade settings

Views: 1,104

Posted By since95

2000 S suspension upgrade settings

After I just ran a track day and AX, I felt my suspension felt tired (98k on stock everything) and overly soft. I had someone drive it at the AX without mentioning it, and their thought was it...

Forum: Boxster Racing Forum

04-25-2018, 06:31 AM

Replies: 28

Limp mode, no codes ?

Views: 7,128

Posted By since95

Didn't happen to me on a Porsche, but in a Chevy...

Didn't happen to me on a Porsche, but in a Chevy truck I had the same issue. For me it was the fly by wire control. I was told the fail to idle is the answer to the old Audi 5000 issue where they...

Forum: Boxster General Discussions

04-04-2018, 03:35 AM

Replies: 19

Finally got most of my projects done on my new 2001 Zanzibar Boxster

Views: 2,718

Posted By since95

That looks great! How did you paint the dash...

That looks great! How did you paint the dash trim? I read where the only way to get it out is to remove the dash, or buy new pieces, line up and drill out where all the screws are, then use a...

Forum: Performance and Technical Chat

03-19-2018, 03:37 PM

Replies: 6

Treating ECU / Immobilizer Pins

Views: 1,739

Posted By since95

Dave80GTSi, I had electrical gremlins in my '94...

Dave80GTSi, I had electrical gremlins in my '94 348 Spyder F car. I found all the grounds corrode on the Italian cars and had a guy at a car show recommend Stabilant 22 after I cleaned them all off....

Forum: Boxster General Discussions

03-08-2018, 07:06 AM

Replies: 21

Short Shift kit

Views: 6,556

Posted By since95

Just did one myself. Trim part on e brake pops...

Just did one myself. Trim part on e brake pops off. The plastic bushing I cut out with a sharp chisel. Couple of wacks, broke it, pulled out the pieces, old shifter comes right out. Once you...

Forum: Boxster General Discussions

01-08-2018, 10:17 AM

Replies: 137

What's the story behind your forum name?

Views: 18,978

Posted By since95

only a 3 month gap in the summer of 2016 between...

only a 3 month gap in the summer of 2016 between trading my 993 and purchasing a 944 to build for my daughter did I not have at least one Porsche in the garage... you guessed it, Since95

Forum: Performance and Technical Chat

01-08-2018, 10:02 AM

Replies: 24

Surprise during 2004 AOS change

Views: 3,497

Posted By since95

I just did the AOS last weekend. Had...

I just did the AOS last weekend. Had transmission out for IMS/RMS/Clutch so super easy access from under car. STILL couldn't get the freaking squeeze connector off the bottom of the AOS, so after...

Forum: Performance and Technical Chat

12-29-2017, 05:58 AM

Replies: 23

Paint your own center console?

Views: 8,622

Posted By since95

really wasn't too bad. I've only tried to wrap a...

really wasn't too bad. I've only tried to wrap a couple simpler items before. It just took a little time and patience. I watched a bunch a videos on YouTube and that certainly made some of the...

Forum: Performance and Technical Chat

12-28-2017, 07:28 PM

Replies: 23

Paint your own center console?

Views: 8,622

Posted By since95

I was going to paint my console but I decided to...

I was going to paint my console but I decided to vinyl wrap it instead. I think it might hold up better to wear and tear than spray paint. I think the wrap was $10 on Amazon. The shift knob I...

Forum: Performance and Technical Chat

12-26-2017, 10:32 AM

Replies: 9

2000S IMS confusion

Views: 2,624

Posted By since95

Bearing was a dual row. I replaced it this past...

Bearing was a dual row. I replaced it this past weekend with LN retrofit. Bearing that came out was still in pristine condition, both seals intact, no play, and based on the style of bearing looks...

Forum: Performance and Technical Chat

12-17-2017, 09:00 AM

Replies: 9

2000S IMS confusion

Views: 2,624

Posted By since95

No snap ring! Thanks for the help. Sent...

No snap ring! Thanks for the help.

Sent from my SM-J700P using Tapatalk

Forum: Performance and Technical Chat

12-17-2017, 06:23 AM

Replies: 9

2000S IMS confusion

Views: 2,624

Posted By since95

2000S IMS confusion

Sorry in advance for bringing this up again, but completely confused with info vs what I found in my car.

Info I'm finding states the 2000 could be either dual row or single row. Pulled tranny...

Forum: Boxster General Discussions

11-20-2017, 09:10 AM

Replies: 18

My New Top -- '99 with Glass Window

Views: 1,775

Posted By since95

That top looks really great! I just picked up a...

That top looks really great! I just picked up a 2000 S and it came with a new glass window top. Any idea how to get the glass window to miss the roll bars in order to access the engine?

Forum: Performance and Technical Chat

11-17-2017, 05:05 PM

Replies: 17

2000 986S for HPDE suggestions

Views: 2,794

Posted By since95

mikefocke Sorry, I thought I put that I...

mikefocke
Sorry, I thought I put that I checked the option sticker, 030 is not an option on the car when new.

Deadeye
since planning to track I'm leaning to track seats so they will hold me...

Forum: Performance and Technical Chat

11-17-2017, 08:28 AM

Replies: 17

2000 986S for HPDE suggestions

Views: 2,794

Posted By since95

Thanks for the input! I wouldn't have realized...

Thanks for the input! I wouldn't have realized to do the pulley, and knowing I need some modification for additional camber is great info as well. I think the GT3 brake ducts are also good advice,...

Forum: Performance and Technical Chat

11-16-2017, 06:49 AM

Replies: 17

2000 986S for HPDE suggestions

Views: 2,794

Posted By since95

2000 986S for HPDE suggestions

Just picked up a 2000 986S last weekend. Long time owner of Porsche cars. Bought the Boxster after owning 70-911T, 84-911 Cab, 81-930, 96-993, 87-944 project for my daughter. Traded the 993 on a...

Showing results 26 to 44 of 44

Page 2 of 2

All times are GMT -8. The time now is 04:55 PM.