Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums

Showing results 1 to 25 of 150
Search took 0.03 seconds.
Search: Posts Made By: Cunningr
Forum: Boxster General Discussions 05-03-2025, 11:04 AM
Replies: 8
Views: 323
Posted By Cunningr
Mine started that after I had the water pump...

Mine started that after I had the water pump replaced, mechanic mentioned the coolant may be low and too it off next day. If there is no coolant leaking your probably low on coolant. Mine was...
Forum: Boxster General Discussions 04-15-2025, 02:28 AM
Replies: 15
Views: 751
Posted By Cunningr
I just had a major service done my car has 57000...

I just had a major service done my car has 57000 Km it had the IMS kit installed when I bought, however the mechanic did recommend the RMS be addressed mostly because I had developed oil leaks. I...
Forum: Boxster General Discussions 04-08-2025, 11:24 AM
Replies: 2
Views: 323
Posted By Cunningr
I just had my water pump changed and thermostat,...

I just had my water pump changed and thermostat, mechanic told me i would probably have to top off next day when it cooled. And it was low, got the low fluid blinking light took maybe 2 liters to...
Forum: Boxster and Cayman Parts for Sale or Wanted 04-04-2025, 06:38 AM
Replies: 2
Views: 300
Posted By Cunningr
I have the Brombacher, and very happy not too...

I have the Brombacher, and very happy not too loud and no drone. I am debating on getting the headers to.
Forum: Show and Tell Gallery 04-02-2025, 01:05 PM
Replies: 595
Views: 138,651
Posted By Cunningr
Bran car is looking good! I havent been very...

Bran car is looking good! I havent been very active on the forum for awhile, but just had my boxster updated service and got me fired up again!
Forum: Performance and Technical Chat 04-02-2025, 06:38 AM
Replies: 2
Views: 843
Posted By Cunningr
Rear spoiler is both automatic and manual, there...

Rear spoiler is both automatic and manual, there is a switch near where the relays and fusers are located to manually raise it. Normal operation it will be down until around 70 MPH. Best...
Forum: Performance and Technical Chat 04-02-2025, 05:44 AM
Replies: 4
Views: 816
Posted By Cunningr
I watched a you tube video the other day where...

I watched a you tube video the other day where the owner did a base dyno run then installed the under drive pulley completed another dyno, dyno show zero HP gains. From other reader the real benefit...
Forum: Boxster General Discussions 04-01-2025, 04:00 AM
Replies: 1
Views: 332
Posted By Cunningr
FYI RENNLINE 986 Phone Mount

So I installed a rennline cell phone mount several years back, I now have new cell phone with magnetic charging, the magnet that came with the holder, didn't hold my phone.

Did a quick check the...
Forum: Boxster & Cayman Detailing Discussion 03-28-2025, 09:16 AM
Replies: 19
Views: 4,441
Posted By Cunningr
Depends on the coating I think, I did a lot of...

Depends on the coating I think, I did a lot of research ahead of time, no sure your familiar with a youtube channel Pan the Organizer I think his called anyway lot of car detailing info.
Forum: New Member Introductions 03-27-2025, 05:20 AM
Replies: 6
Views: 1,371
Posted By Cunningr
Hello people I too am back active on the forum!...

Hello people I too am back active on the forum! :cheers:
Forum: Boxster & Cayman Detailing Discussion 03-27-2025, 02:50 AM
Replies: 19
Views: 4,441
Posted By Cunningr
Old thread, I did my 986 I did a complete DIY...

Old thread, I did my 986 I did a complete DIY detail chemical iron removal, wash, clay, 3 step cut and polish. I used the cerakote professional easy to use but you have to follow the instructions. ...
Forum: Boxster General Discussions 03-14-2023, 11:58 PM
Replies: 5
Views: 1,344
Posted By Cunningr
I just received the tune from FVD for my 2000 S. ...

I just received the tune from FVD for my 2000 S. They have a progressive tune program if you buy the mods from them at the moment I am waiting on my plenum throttle body to arrive. So my tune will...
Forum: Boxster General Discussions 03-06-2023, 12:31 PM
Replies: 11
Views: 1,706
Posted By Cunningr
I used the through the dash method was easy to...

I used the through the dash method was easy to access in 10 minutes i was in cutting the vent.
Only really good tip i found was to use a magnet to help get the alum tape in place.
Forum: Boxster General Discussions 02-26-2023, 08:15 AM
Replies: 11
Views: 1,706
Posted By Cunningr
Was easier to get to than expected, took longer...

Was easier to get to than expected, took longer than expected to clean old foam and using the 3m tape took patience. Today my right hand and arm look like they were in a blender more Knick's and...
Forum: Boxster General Discussions 02-25-2023, 06:39 AM
Replies: 11
Views: 1,706
Posted By Cunningr
Fixed blowing foam today

Hello been awhile since I been around hope everyone is well. Well after procrastinating for 3 or 4 years I finally pulled the unit front and cut the vent duct. Cleaned as much old foam out that I...
Forum: Boxster General Discussions 10-16-2021, 09:36 AM
Replies: 2
Views: 806
Posted By Cunningr
I bought replacements for mine, very easy to...

I bought replacements for mine, very easy to install but you have to take the door panel off. Old plastic was too brittle to expoxy.
Forum: Boxster General Discussions 07-02-2021, 06:51 AM
Replies: 14
Views: 1,028
Posted By Cunningr
This maybe a silly question, did you have it...

This maybe a silly question, did you have it running before you replaced the battery? You said you just bought it, some people buy and have the cars delivered so just to make sure when the no crank...
Forum: Boxster General Discussions 06-21-2021, 08:18 AM
Replies: 13
Views: 1,321
Posted By Cunningr
I cant vouch for the kit in question, but I have...

I cant vouch for the kit in question, but I have purchased several items from Sun Coast with no issue.
Forum: New Member Introductions 06-16-2021, 12:03 PM
Replies: 4
Views: 999
Posted By Cunningr
Welcome to the forum! I am flying into Huntsville...

Welcome to the forum! I am flying into Huntsville in a couple of weeks.
Forum: Performance and Technical Chat 06-08-2021, 10:26 AM
Replies: 25
Views: 7,277
Posted By Cunningr
Yeah that is where I am, want the performance but...

Yeah that is where I am, want the performance but not really more sound.
Forum: Performance and Technical Chat 06-08-2021, 07:48 AM
Replies: 25
Views: 7,277
Posted By Cunningr
I almost purchased a set of these a few months...

I almost purchased a set of these a few months back, my car is euro spec should be a bolt in change I would think. Looking forward to your report, I have the brombacher muffler and very pleased.
Forum: Boxster General Discussions 05-20-2021, 08:13 AM
Replies: 8
Views: 795
Posted By Cunningr
I am with the general consensus, look fine not...

I am with the general consensus, look fine not overly stated so perhaps not worry about it unless there bothering you.

I am the guy no tattoos, but like checking out others who have them. I...
Forum: Performance and Technical Chat 05-13-2021, 08:50 AM
Replies: 41
Views: 8,023
Posted By Cunningr
This has been a very discussed topic on the...

This has been a very discussed topic on the forum. Pros and cons, price. I think in the end for best results it needs to be used with an exhaust upgrade to see most benefit. This is based off...
Forum: Boxster General Discussions 05-11-2021, 08:10 AM
Replies: 21
Views: 2,450
Posted By Cunningr
My 2000 S came with the factory hard top, I have...

My 2000 S came with the factory hard top, I have used it 3 months out of the 5 years I have owned the car. I like the change in looks with it on, but I bought it because its a convertible. Previous...
Forum: Boxster General Discussions 05-08-2021, 09:49 AM
Replies: 43
Views: 8,444
Posted By Cunningr
I used an adapter for a mitshibushi, i think was...

I used an adapter for a mitshibushi, i think was .5” to install 6.5” woofers in the doors. Did not have a clearance issue. I bought some second hand nokia door boxes for 986 to cut up and modify then...
Showing results 1 to 25 of 150

 
Forum Jump


All times are GMT -8. The time now is 04:33 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page