986 Forum - The Community for Porsche Boxster & Cayman Owners

		986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums
Search Results

Garage

Showing results 1 to 6 of 6
Search took 0.01 seconds. Search: Posts Made By: maz8062

Forum: Boxster General Discussions

08-30-2025, 08:40 PM

Replies: 8

alternator removal

Views: 1,473

Posted By maz8062

This is the part of the job that very few YT...

This is the part of the job that very few YT videos or comments online address. Yes, it is hard to remove but installation is anything but “reverse of removal”. Intuitive it is not.

Having owned...

Forum: Boxster General Discussions

08-05-2025, 04:40 AM

Replies: 8

Water Pump Failure and Overheat

Views: 917

Posted By maz8062

I think you could be fine, but once you put it...

I think you could be fine, but once you put it back together, sell it on as you don't know when/if the damage will manifest itself, or not.

You should have switched the car off at the low coolant...

Forum: DIY Project Guides

06-22-2025, 08:04 AM

Replies: 18

Fix sagging soft-top coming unstuck at rear

Views: 11,296

Posted By maz8062

Great thread, I love it. If any of you were...

Great thread, I love it.

If any of you were doing it again today, would you do anything differently, assuming it has held up till now?

Forum: Boxster General Discussions

06-13-2025, 11:11 AM

Replies: 1

MY03 3.2 Vacuum leak and wild RKAT numbers

Views: 190

Posted By maz8062

Not a dickie bird from the collective Durametric...

Not a dickie bird from the collective Durametric pros on here.

My main concern is the RKAT numbers, which are at 6.98 (durametric values) while FRA numbers are below 1.

I also have my own 997.1...

Forum: Boxster General Discussions

06-12-2025, 02:56 AM

Replies: 1

MY03 3.2 Vacuum leak and wild RKAT numbers

Views: 190

Posted By maz8062

MY03 3.2 Vacuum leak and wild RKAT numbers

Hey,

I've been struggling with a vacuum leak on my new-to-me MY03 3.2S

Attached are a couple of Durametric files from an earlier datalog (idle only). The obscured top line is FRA (bank 1)

My...

Forum: Boxster General Discussions

06-04-2025, 02:21 AM

Replies: 8

986.2 misfire at high rpm

Views: 1,307

Posted By maz8062

I'm surprised no one mentioned MAF sensor. ...

I'm surprised no one mentioned MAF sensor.

If you have Durametric you can datalog the MAF at idle for Hot start voltage and readings. If out of spec swap it out and it should be fine.

Showing results 1 to 6 of 6

All times are GMT -8. The time now is 11:12 AM.