I still have a few spots open for this class. At the present I have slots for 4 more attendees, the next class after this one will be in mid summer 2010, another in the Fall of 2010.
Details are up on my site, here.
http://www.flat6innovations.com/classes/engine-rebuild-school
The class will be primarily based on lectures and presentations with some first hand practical application portions as well. These will be focused on the correct use of special tools and proficiency with piston and wrist pin insertion on bank 4-6 during assembly. I'll also go over cam timing procedures and special tool usage.
The goal will be for each attendee of the class to successfully assemble their own M96 with the knowledge gained from the periods of instruction. The most difficult portion of M96 assembly is piston pin/retaining clip insertion and each attendee will successfully complete this procedure with our instruction before the class is completed... I have a few tricks that will be shared.
Info on lodging and transportation is available via email.. We are in a beautiful area of N.E. Georgia with Mountain cabins available 5 miles away, or cheap hotel rooms 7 miles away, in the Alpine Village of Helen GA (with lots of German Beer and food available!)..
Airtran flies into Atlanta (1.5 hrs away) as a hub and has cheap fares from most any part of the country..
Cost of this class is 499.00 per person, (with early registration, 599.00 at the normal rate) the classes we have planned after this one will be more expensive...(799.00)
Anyone interested email my assistant, Dean at
info@flat6innovations.com and he'll get you all the info...
The class will be instructed b y yours truly and we'll have a couple of special guests as well.
Threaded Mode
