Ball bearing short shifter !

[Ben006]

Originally Posted by Pdwight

I could never believe how much better the shift felt after installation . My replacement shifter fit like a glove and is so much more definite now.

I do have one question while I was quite careful with the cable placement and getting it back where is is supposed to be, second gear feels like it could be a bit further or it should move slightly more to engage better ??

It does not slip or try to slip out of gear....just feels like it not quite there....anyone else have this same situation ?

Thanks
Dwight

I'm glad you like it !

I put the cables in the exact same place where they were, and I don't feel that. did you remove the green piece in the bottom of the assembly ? it can interfere with the cables.

maybe try to move the cable a little be more inside the threaded receiver (I don't know how to call it ?).


The most "difficult" part for me was to break to old bushings out, I was a little afraid, but after that, should be easy

Ben

[Pdwight]

I did not remove the green piece....drove it quite a bit today and all gears are engaging well and staying where they should....if it's working leave it alone

[Duezzer]

Installed mine yesterday.

Very nice - Like it a lot.

Thanks

Duezzer