DIY Instructions - Avic D3 Installation

[trieullionaire]

Initially it was just a show and tell but since we winded up doing a lot of instructions, thought it might make sense to list it in the proper place.

[blinkwatt]

Darn nice instructions!

[trieullionaire]

Wiring Instructions with Pictures

[Kevfra]

I recently did this install and I have one suggestion on a change in sequence. Where it is indicated to use the Dremal to remove the center brace...I suggest you wait and first remove the entire factory housing, then use the Dremal once it's on your work bench. Much cleaner than doing it in the car!

[trieullionaire]

Yes, if I had to do it again, I would of taken out the plastic housing and cut it on a work bench too becos eventually you have to take it out anyways.

[S3adrag0n]

Great documentation... nicely done!! I'm in the process of doing it myself but didn't know where to begin. This will definitely help .

[S3adrag0n]

Well, I finaly got to it and bought the install kit from Ebay and decided to go with the Avic Z2. Did the video bypass, getting a HDD to upgrade my Z2 to the Z3 software (http://www.avic411.com).

[Chuck W.]

I just completed installing a Kenwood DNX5120 using these DIY instructions. Many thanks!