Hood Drip tray Clips
 

I have a 2000 986 boxster. We had a drama a few years ago when one of the drip trays on the hood split, flooded the passengers floor and killed the computer! Cost £1000s to repair but we paid up to keep the car. I had to photograph the engine bay for the insurers and I see that the piece of leathercloth that catches water at the back of the hood is not attached to the clips on the rear bulkhead. There are a couple of black hooks on the bulkhead but no obvious way of attaching the plastic moulding sewn onto the back drip fabric to them. Has anyone got a diagram of what should be there or a photo so I can buy whatever is necessary to refit this part?

Thanks

All sorted now, the hooks have been installed upside down on my car, obviously always been like since I bought it!!

Thanks to everyone who has viewed this issue

Couldn't post that pic for us? :rolleyes:

Assuming you are talking about parts referenced in image 2 highlighted in red box below...

Clips / hooks (4) on either side are all that's used / needed. Plastic u-channel (3)sewn to apron at rear of top simply slips up into hooks and is held in place under tension created.

Good luck :)

http://986forum.com/forums/uploads02...1726934230.jpg

Thanks !!
 

Thanks for the diagrams. That solves the problem....the hooks are upside down??? I'll sort them out now. Thanks for all the help!!

Sorry, I meant to Reply!!
 

Thanks Burg for the advice, The hooks have been installed upside down on mine...obviously always been like it since we had the car!!!

I'll go and reverse them now. Thanks everyone who's looked at this for me.