![]() |
Oil cap looks moist. Should I be worried?
I'm changing the oil in my 99' boxster and I noticed taking the oil cap off was hard. Then when I got it off there was a weird moist oil residue on the top of the filler and the cap looked wet. Should I be worried?
http://986forum.com/forums/uploads02...1615050132.jpg |
Also the oil that came out looked fine. The dipstick looked normal. But I think my AOS might be going bad.
|
How do you drive your car? Lots of short trips that barely get engine warm? Looks to me like engine not getting hot enough to cook off water vapor. As far as AOS get a manometer and check.
|
Quote:
|
Quote:
If you are not short driving it then you may have other issues. |
Quote:
|
Quote:
. |
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Depends also of the climate you're at.
We used to have 'normal' 20-30 years ago that if you do not get the car hot for a long time at least couple of times a week (if driven daily) during winter when the temps do hover between 30-0 F, then the oil cap looked just like on the OP's picture. Summer was never a problem. Also, the coffee color stuff is so small amount, that makes me to believe the current colder weather could be the culprint of this - or very recently started small mix of water to oil. |
Quote:
|
Quote:
|
looking at your picture I see quite a bit of water droplets on the underside of the oil filler cap. Not good.
Also due to the fact that your slowly loosing coolant that makes the water droplets more suspect. So finding the reason for the coolant loose is rather important. Things you can do: Coolant system pressure test. Test coolant system for presence of hydrocarbons, I think you can still get test kits for this at auto parts stores. Send an oil sample out and have it tested for the presence of antifreeze. |
Quote:
|
Quote:
It will work on any system. |
Quote:
. |
[QUOTE=Gilles;631655]Bad O-rings on the he heat exchanger could be a cause then, right?
.[/QUOTE NO. This is physically not possible. 4 O-rings that contain pressures greater than atmospheric (oil at 15-50 psi and coolant at ~18 psi), cannot leak into each other separated by 2+ inches through the atmosphere @0 psi (14 psia) unless the O rings were gone and the leak was so bad they drained into the other from residual on the engine. But then I think the fluid on the ground would be hard to not notice. Edit If I ruined a long standing joke like foglights then I apologize. |
hopefully you have some oil that you could send out to get analyzed might help find the answer..
|
All times are GMT -8. The time now is 02:29 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website