Replacement headlight seal/ gasket

[JBauer]

Originally Posted by rfuerst911sc

Good tip I'm sure there are a lot of old gooey gaskets out there in need of replacement . I was lucky to purchase a used set of OEM gaskets in perfect condition so for now I'm set .

Where did you find those? 😲

[rfuerst911sc]

Originally Posted by JBauer

Where did you find those? 😲

Just happened to find a local set from a forum member .......... a one in a million shot

[flouese]

Will this work for the tail lights?

[Black Knight]

Originally Posted by flouese

Will this work for the tail lights?

I dunno.
I am needing the gasket / trim seal for the hood. Mine was all brittle and just flaked away. I can't locate that piece either. I guess mcmaster is a good place to start

[JBauer]

Originally Posted by flouese

Will this work for the tail lights?

I don't know but they have diff sizes. You might measure one and see if they have anything thst would work.

[robdelorenzo]

Thanks for this. I ordered some and it arrives today. Gooey washers that are spreading black gunk and streaks are going away. Problem solved for $15.00. Now on to the next project....

[JBauer]

Originally Posted by robdelorenzo

Thanks for this. I ordered some and it arrives today. Gooey washers that are spreading black gunk and streaks are going away. Problem solved for $15.00. Now on to the next project....

Great, let me know how it works out. Make sure you clean the edge of the light where it will be sticking to. I forgot the first time ��
Also make the rubber a little longer than needed, then trim once its locked in. If any parts are sticking out from locking the headlight in they can be worked level will a thin piece of plastic edge or your finger. After it was clamped awhile it sticks pretty well incase you need to remove the light. Good luck.

[JBauer]

I finished mine but forgot to post pics. Incase anyone is curious.
Still need to tuck it here and there.