Quote:
Originally Posted by rfuerst911sc
That is a tight fit where the ends meet the outline of the headlight , did you have to trim the ends of the vent or did they " just fit " ? The screen sure helps hide what is underneath . The 997 hood must have a smaller radius to it as the vent follows the hood edge line much closer than in your pics . But your color hides that quite well . In my case I am thinking of leaving it black , against my Arctic Silver that hood fit may stand out too much . Will have to think this over . Thank you for the follow up pics .  |
I trimmed probably 1/2 inch off each side. I should of went just a hair more and contoured it flatter at the ends to make it flow together better. May end up doing that. The mesh I used was really flimsy. I think I'm going to get the thicker plastic mesh.
Threaded Mode
