|
Convertible top repair bottom became untucked.
http://imgur.com/VTJfE8Z.jpg
I tried searching to see what others have done to fix this, but had a hard time coming up with search terms. The top became untucked from from, What is the best was to get this back in place. Do I use an adhesive? |
Double sided 3m tape. Separate all of the bottom, clean it well with acetone, and redo the entire bottom edge.
|
|
I used 3M spray adhesive....spray onto paper plate and apply with foam brush. Two years and still holding.
|
Thanks guys. Advise was helpful, I just called a top shop and they want $65. How long do you think this will take if I do it myself?
|
Using 3m it took me about 5 minutes to apply and about 10 min to set up enough to let it finish on its own. I opened the top enough to take the tension off the area.
|
| All times are GMT -8. The time now is 02:52 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website