Things to do while Dash Removed?
I'm almost ready to remove my dash for the dye/repair wire... I was thinking, besides the 4th Stalk which i can do with the dash in, what mods or upgrades can I perform while it's out. It will be out for a couple days for the dye.
Sent from my SM-G925T using Tapatalk |
HVAC flap foam removal/replacement.
|
Speaker upgrade?
|
Mechanical or electrical ignition switch replacement.
|
If you want to paint the plastic trim strips that run across the middle of the dash. With the dash out it will be MUCH MUCH easier to remove these. Actually you will most likely be removing these from the dash before the dye job. Either way much easier to get them off and on with the dash out.
|
Quote:
Sent from my SM-G925T using Tapatalk |
Quote:
Sent from my SM-G925T using Tapatalk |
Quote:
Sent from my SM-G925T using Tapatalk |
With the dash out, it doesn't look like there is much to do, the ignition switch maybe. Mine hasn't given any issues but possibly good idea while it's out
Sent from my SM-G925T using Tapatalk |
Quote:
http://i875.photobucket.com/albums/a...25FAD47C9E.jpg |
Image is broken. I used some to adapt the 01 vent with the 04 dash center face. But I believe I have more
Sent from my SM-G925T using Tapatalk |
I fixed the image...I think. I can see it, anyway.
|
I'll look at it. Question, when the vents... On the HVaC display aren't active, should any come out of the center?
Sent from my SM-G925T using Tapatalk |
If you wanted to change the horizontal trim strips to, say carbon fiber, aluminum, etc., doing it with the dash out is easiest.
|
Quote:
|
Quote:
I did however locate my wire issue. Despite the previous owner installing a fuse that was higher than it should be, seems the drop top switch is what shorted out while it wasn't connected and luckily is the only damage. http://images.tapatalk-cdn.com/16/01...98942e0a20.jpg So the rest of the wires are fine. It's just from here over the steering column to the center and to the switch. I'll probably just cut this wire. The car is permanently hardtop and the only reason I have to open the deck would be to remove the sub enclosure so I could install a switch here. Maybe use the spoiler switch since I wanna move it to a better location. Sent from my SM-G925T using Tapatalk |
How will you get in to change air filter, top up power steering, etc.?
|
Quote:
http://images.tapatalk-cdn.com/16/01...9b3acf53d0.jpg Sent from my SM-G925T using Tapatalk |
All times are GMT -8. The time now is 03:10 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website