Custom wind deflector.
I'm working on a wind deflector and filling panel under roll bar.
Any thoughts. |
Come up with a great idea and quality product and you can sell it on the forum. I've seen it done and bought the (awesome) products.
|
I tried something similar last winter, to make a single panel to replace the centre deflector and the clip in pices that fit in the roll bar. I had it made of .0125" plexi, and it didn't fit bad, but I couldn't get the roll bar padding to hold it in the way I wanted and gave up on the project.
I hope you have better luck than I did. |
Well, should the lower in- fill be Plex or alum?
You all want to keep carpet too? Thx m Ps. What are people's thoughts on the stock roll bar pads? |
At this point I have first gen working parts.
Under roll bar is "inside" lower bar support just up against eng bay lid, w alum 90 bar @ carpet anchoring points. Upper section is "behind" roll bar. Well forming is about heat and proper location of anchoring points. & well I have no problems drilling holes... |
|
I vote someone create/design a windscreen mesh insert replacement! I'm in dire need of a set but cant justify paying my soul for 2 pieces of plastic with a bunch of little holes in it.
|
Quote:
the holes is what makes it expensive :D |
I paid......
Quote:
|
All times are GMT -8. The time now is 05:12 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website