Hi try and figure this one out. So recovered the top did a good job no wrinkles. Then went to close it and it was a couple of inches away from window frame. So the dumb ass that I am I pulled it and snapped the ball joints. Got in there via the roll bars and popped the clam shell ball joints. Good so far (thank for the posts on here). Then cycled the top to make sure the clam shell opens and closes (did remove the top push rods) cool. Ordered new push rods, last night wanted to open the clam shell with the button and the thing only goes in one direction (closed) no matter if you push the button open or close. So popped the clam shell push rods again. Open the clam shell by hand and the motor functions in forward and reverse. As soon as I close the clam shell (micro switch goes to close) the motor only turns in closed position. It will not turn the other way. Guys what the hell I am out of ideas.
Threaded Mode
