|
Stalling after MAF cleaning.
97' just turned 80k, less that 3k in the last 12 mos. Had it about 3years, only had oil changes-no known issues.
CEL lit the other day-
P0108 code (if I remember correctly) - looked it up at the time and the consensus was dirty MAF. Took it out, spayed MAF cleaner in and out and reinstalled it. Didn't get to test it right away. First time I've even had the cover off the engine compartment.
Next day I cranked it, no start. Second, third crank, sluggish start-stumble, stall. Finally caught, runs rough- went for a neighborhood drive 1/4 mi. away it stalls driving. Re-start, made it home. Sits for 4 hours.
Round2, starts right up. Back down the drive-stall. CEL light on P0102. Drove it a bit, ran better with the CEL on. Reset the code. Drove home. Stalled again 1/2 way home, and again pulling into the drive.
Gonna check the MAF installation to make sure I got it back in and properly connected.
Any suggestions would be appreciated.
Jb
|
Threaded Mode
