![]() |
These posts really get you thinking about what you've done yourself. I have done the following
-Tires -Alignment -Door Lock Mechanism -Horn plate in steering wheel -Ignition Switch replacement -Top Replacement -Brake Pad replacement -MAF -Air Filter -Cabin Filter To do: -Motor Mount -Plugs -Suspension/bushings -Control Arms -IMS |
Quote:
|
And i forgot the new front original bumper, shocks for hood and trunk, collant flush.
What a money pit! |
Quote:
Since you live in Richmond, I suggest that you take your car to Luftechnic and ask them to check it over. I realize that asking a mechanic if anything needs to be repaired on your car is liking asking a barber if you need a haircut. They are both likely to say "yes". I was experiencing a lot of problems with my car when I bought it. I found that while I did spend more than a few dollars on it, that they communicated very well with me and gave me a good idea of what I was facing. I think that Luftechnic's labor rates are a little lower than Euroclassics and that they are willing to work with an owner who does some tasks on a DIY basis. Good luck. |
[QUOTE=KevinH1990;279895]I understand your frustration with being stranded. I had a lot of initial problems with my car.
Since you live in Richmond, I suggest that you take your car to Luftechnic and ask them to check it over. I realize that asking a mechanic if anything needs to be repaired on your car is liking asking a barber if you need a haircut. They are both likely to say "yes". It takes a very brave man or woman to do this but great if you can find that suitable garage that would work on your behalf and not go town to it. I credit your great advice. Too bad that insurance requirements prevent the customer from occasionally looking over the mechanic's shoulder. From another thread I believe this is frowned on. My worst nightmare is to find later for example that my new replacement ceramic ims was sitting on the workbench and had never been installed:mad: |
Quote:
1999 Z3 Coupe- failed seat bracket bushings, window regulator required significant structural reinforcement, air vents get sucked out of the windows, hood cable which required the removal of the front end of the car, rear hatch rattles, strut bushings. You had that car for eight months. 1995 BMW 540/6: Head gasket, valve cover gaskets, $432 key replacement, head light ballasts that blew up, seat cables snapped and locked in position, OBC fan that sounded like a miniature weed wacker in the dash, door rust even though it lived inside, clutch slave, clutch master, idler pulley, glove box latches failed, steering box failure. You had that car for a year... Should we talk about the E46 M3 or even the M52 swap car you had before that or have I been able to make my point?? |
Quote:
It's a little reassuring that some of you have experienced the same thing when you first purchased the car. Maybe I'm almost out of the woods. I will say that the car is very easy to work on, and yes far simpler then the M3 which was a complete nightmare. There were several jobs on that thing that took days to finish! Cheers, Stu |
I am at 86,000 miles in my 2000 2.7 and the only things I have replaced are Water Pump and Rear plastic window and 1 inner tie rod and a few light bulbs. Starter is starting to go bad, but still has at least 1 year left in it. My rough idle was fixed by cleaning the throttle body.
Thats it, as far as I know from previous maintenance records, everything else is original except brake pads, tires, and air filter. I expect your Boxster to last a while without any major problems since you just fixed the problem areas. IMS does not happen to every engine. Get the "IMS Guardian" to be safe. |
Sounds like routine maintenance to me. Other than being stranded, which is horrible, nothing sounds out of bounds - not enough to call the car a poorly designed.....
|
All times are GMT -8. The time now is 05:49 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website