Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 08-21-2010, 11:36 AM   #1
HB.
Registered User
 
Join Date: Oct 2004
Posts: 152
.How do you check the power steering fluid? Last night while driving home my car started smoking a little bit, then turned off. When I cranked it back up I noticed it was extremely hard to turn the wheel. And, for some reason my battery and abs light stay lit.
HB. is offline   Reply With Quote
Old 08-21-2010, 02:11 PM   #2
07 Carrera S Cab
 
Boxtaboy's Avatar
 
Join Date: Nov 2005
Location: New Jersey
Posts: 2,273
Garage
HB, that sounds like your serpentine belt just broke. That belt drives all your accessories including the power steering pump, water pump, alternator, etc. So if it snaps, you lose everything and cannot drive the car until you replace the belt.

Belt replacement:
http://www.pelicanparts.com/techarticles/Boxster_Tech/05-BASICS-Belt/05-BASICS-Belt.htm
__________________
Current: 07 Carrera S Cab in Midnight Blue

Previous: 01 Boxster in Arctic Silver, 86 944 in Guards Red
Boxtaboy is offline   Reply With Quote
Old 08-21-2010, 02:21 PM   #3
HB.
Registered User
 
Join Date: Oct 2004
Posts: 152
I can drive the car, it's just really hard to turn the wheel. I took it for a test drive today. On my way back home the car got really hot. I pulled off to the side of the road, and noticed coolant was leaking all over the ground just right in front of my passenger side rear wheel. This sucks because I just had my water pump & reservoir replaced just last year.
HB. is offline   Reply With Quote
Old 08-21-2010, 02:33 PM   #4
07 Carrera S Cab
 
Boxtaboy's Avatar
 
Join Date: Nov 2005
Location: New Jersey
Posts: 2,273
Garage
What I'm trying to do is explain to you that when your belt breaks you can drive the car, but if you do, you will overheat the car since the water pump will not be running anymore, as well as the power steering being lost because that pump is also run off the belt. Do not drive the car until you replace the belt!!!!! Also, your battery will eventually die because the alternator which recharges the battery will not run without the belt.
__________________
Current: 07 Carrera S Cab in Midnight Blue

Previous: 01 Boxster in Arctic Silver, 86 944 in Guards Red
Boxtaboy is offline   Reply With Quote
Old 08-21-2010, 10:41 PM   #5
HB.
Registered User
 
Join Date: Oct 2004
Posts: 152
Oh, ok thanks! That makes sense. I hope that it's just the belt that needs replacing. Is it normal for them to go bad in about a year's time? I had mine replaced last year when the shop replaced my water pump. Would you say hearing a wine sound upon acceleration being a good indication of the belt going bad?
HB. is offline   Reply With Quote
Old 08-22-2010, 03:52 AM   #6
07 Carrera S Cab
 
Boxtaboy's Avatar
 
Join Date: Nov 2005
Location: New Jersey
Posts: 2,273
Garage
Normally, a new belt can last over 60k miles or 4 yrs (the recommended replacement schedule), but it is possible that one of the rollers that rolls the belt seized or became wobbly. If that happened, the belt might have slowly started to slip off, and when it slips off, it will stop powering all the other rollers which operate your power steering, A/C, alternator, and water pump. If you continue to drive the car, the car can get so overheated that you end up totally ruining your engine and will need a new one, so never continue driving the car next time you feel the loss of power steering and see the car starting to overheat.

Even if you have a brand new water pump in there, the water pump won't run without a belt turning it, and therefore your car will overheat.
__________________
Current: 07 Carrera S Cab in Midnight Blue

Previous: 01 Boxster in Arctic Silver, 86 944 in Guards Red
Boxtaboy is offline   Reply With Quote
Old 08-22-2010, 12:03 PM   #7
HB.
Registered User
 
Join Date: Oct 2004
Posts: 152
Thanks a lot! You were right about the belt. I'm in the process of removing the old belt now. I've run into a bit of a speed bump, about 1 1/2 of the belt is wrapped behind one of the pulleys, and I'm having problems getting it off. I think if I can get a small sharp knife I should be able to cut it loose.
HB. is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 03:19 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page