FS: RMS IMS tools
 

I sold my Boxster and have some tools to sell now. I have the white Delrin RMS tool from Cheetah that presses the new seal in 13mm deep. $50 shipped

I also have the tool that came with the LN IMS upgrade that pulls out the old bearing. I don't remember what I paid for it and I see they don't sell the kit to mere mortals anymore so I don't really know what it's worth. I'm asking $50 shipped for the puller. If that's way out of line let me know.

Email me direct at sholst@pacinfo.com for a quicker reply

Thanks.

Steve

The LN IMS tool is a good deal.

Confirm what you have, if so, I will take them.
 

Good afternoon,
You did a great job describing the RMS tool, but your description of the LN tool leaves me with questions. To remove and replace the IMS bearing LN does have tool KIT, not just a bearing puller, but also camshaft locking plates, TDC pin, etc. Are you selling the kit?

If so, I take all of the tools. I'll send an email and PM with Paypal address so you can send a money request/ invoice.

Shipping address will be in PM too.

Thanks,
Joe

RMS tool is pending. When I bought the LN bearing 4 years ago there really wasn't a "kit" just the puller. I'll post some pictures tomorrow.

Steve

RMS tool is sold. Here's the IMS tool from LN:

http://986forum.com/forums/uploads01/tool1415495826.jpg

Steve

Bearing puller is pending.

Steve