Go Back   986 Forum - for Porsche Boxster & Cayman Owners > Search Forums
Reload this Page Search Results
Register Garage FAQ Members List Social Groups Calendar Search Today's Posts Mark Forums Read

Page 1 of 6 1 2 3 Last »
Showing results 1 to 25 of 150
Search took 0.05 seconds. Search: Posts Made By: 911monty
Forum: Boxster and Cayman Parts for Sale or Wanted 04-21-2021, 04:45 PM
Replies: 2
Views: 112
Posted By 911monty
Model #46-193803 is the correct model number. ...

Model #46-193803 is the correct model number.


https://www.vivid racing.com/bilstein-b12-prokit-suspension-kit-porsche-986-boxster-front-and-rear-19972004-p-151564177.html
Forum: Boxster General Discussions 04-19-2021, 03:59 PM
Replies: 4
Views: 152
Posted By 911monty
Part #191-853-615-A available from forum sponsor.

Part #191-853-615-A available from forum sponsor.
Forum: Boxster and Cayman Parts for Sale or Wanted 04-16-2021, 01:43 PM
Replies: 6
Views: 462
Posted By 911monty
Now why do something like that?????? I got $6.00...

Now why do something like that?????? I got $6.00 for 4 at the recycle center for the scrap aluminum!
Forum: Performance and Technical chat 04-14-2021, 11:06 AM
Replies: 14
Views: 408
Posted By 911monty
Accessory belt been changed recently?

Accessory belt been changed recently?
Forum: Performance and Technical chat 04-07-2021, 03:23 PM
Replies: 13
Views: 301
Posted By 911monty
Can't answer from the pic, but the fuel filter is...

Can't answer from the pic, but the fuel filter is close by. Trace from there?
Forum: Boxster General Discussions 04-04-2021, 10:24 AM
Replies: 11
Views: 300
Posted By 911monty
Have a look at the new part. It is not press fit....

Have a look at the new part. It is not press fit. There is a square block on the end with 2 yellow rectangular squares that get pressed in to release the tube from the block.
Forum: Boxster General Discussions 04-03-2021, 12:22 PM
Replies: 11
Views: 300
Posted By 911monty
Since they are apparently the same vintage...

Since they are apparently the same vintage pieces, they are hard and subject to breakage like the dipstick tube if subjected to movement and are all in the same approximate location where you will be...
Forum: Boxster General Discussions 04-03-2021, 12:07 PM
Replies: 11
Views: 300
Posted By 911monty
That is your dipstick tube. It will need to be...

That is your dipstick tube. It will need to be replaced. The wire is the dipstick.

Just an FYI; Now the oil fill tube, the bank 2 vent line to the bottom connection of the AOS and all the small...
Forum: Boxster General Discussions 03-18-2021, 02:59 PM
Replies: 8
Views: 299
Posted By 911monty
Just FYI. The hose you need is not the hose that...

Just FYI. The hose you need is not the hose that goes to bank 2, although due to age it could be replaced. The hose you need is the short hose that goes to the manifold at the TB. Pelican has it...
Forum: Boxster General Discussions 03-08-2021, 04:24 PM
Replies: 20
Views: 610
Posted By 911monty
[QUOTE=Gilles;631655]Bad O-rings on the he heat...

[QUOTE=Gilles;631655]Bad O-rings on the he heat exchanger could be a cause then, right?
.[/QUOTE

NO. This is physically not possible. 4 O-rings that contain pressures greater than atmospheric...
Forum: Boxster General Discussions 03-08-2021, 03:29 PM
Replies: 20
Views: 529
Posted By 911monty
Okay your car is the early model. My post above...

Okay your car is the early model. My post above should work. These cars have switches latches and relays to make sure nothing breaks. The relay has to know where the top is before the switch will...
Forum: Boxster General Discussions 03-08-2021, 03:08 PM
Replies: 20
Views: 529
Posted By 911monty
What year is your car. The early cars have a...

What year is your car. The early cars have a switch at the b pillar driver side. With no top bow depressing that switch the relay may be confused on timing. I'd try depressing the switch then attempt...
Forum: Boxster General Discussions 03-06-2021, 08:58 AM
Replies: 6
Views: 295
Posted By 911monty
We used to call it "blowing out the carbon"...

We used to call it "blowing out the carbon" Usually seen when a little old lady from Pasadena tries to merge onto freeway in front of a semi.
Forum: Boxster General Discussions 03-06-2021, 08:52 AM
Replies: 20
Views: 610
Posted By 911monty
The cap would show as an air leak. As engine...

The cap would show as an air leak. As engine cools water will condense inside the case. When you say usually always gets up to temp do you mean you get it to 180 deg and drive for 20 min or more or...
Forum: Boxster General Discussions 03-06-2021, 08:40 AM
Replies: 20
Views: 610
Posted By 911monty
How do you drive your car? Lots of short trips...

How do you drive your car? Lots of short trips that barely get engine warm? Looks to me like engine not getting hot enough to cook off water vapor. As far as AOS get a manometer and check.
Forum: Performance and Technical chat 02-26-2021, 06:59 AM
Replies: 8
Views: 256
Posted By 911monty
When i had mine out it appeared to be regular...

When i had mine out it appeared to be regular 1/2" NPT. I didn't test, so not positive.
Forum: Boxster General Discussions 02-25-2021, 07:05 AM
Replies: 5
Views: 238
Posted By 911monty
You will only need to replace bell housing bolts...

You will only need to replace bell housing bolts if you lose one. Converter to flex plate can also be reused and can be replaced later without pulling the trans if you choose to.

Now, you recently...
Forum: Boxster General Discussions 02-24-2021, 10:21 AM
Replies: 5
Views: 238
Posted By 911monty
The Pelican Torque converter seal is the correct...

The Pelican Torque converter seal is the correct part. Buy the Porsche seal. Even though the other is OEM my experience is they are not of equal quality. Not worth a few bucks difference.

Yes...
Forum: DIY Project Guides 02-17-2021, 05:31 PM
Replies: 22
Views: 696
Posted By 911monty
I didn't call you dumb, a cardiovascular surgeon?...

I didn't call you dumb, a cardiovascular surgeon? clearly you are not. I was referring to the flippant joke you made to BYP's comment about a fact.I am not prone to using emojis and LOLS. So carry on...
Forum: Boxster General Discussions 02-17-2021, 03:00 PM
Replies: 22
Views: 569
Posted By 911monty
Definitely worse! The rubber in the tire loses...

Definitely worse! The rubber in the tire loses the ability to flex and cracks instead!
Forum: Boxster General Discussions 02-17-2021, 01:46 PM
Replies: 22
Views: 569
Posted By 911monty
Plus one on this. I have a 4runner that did the...

Plus one on this. I have a 4runner that did the same thing. Couldn't leave a stop light due to wheel speed difference and applying the brakes. Turned off traction control and back to normal.
Forum: DIY Project Guides 02-17-2021, 01:40 PM
Replies: 22
Views: 696
Posted By 911monty
And this really? According to the first Rule of...

And this really? According to the first Rule of Thermodynamics it is a fact.
Forum: DIY Project Guides 02-17-2021, 01:38 PM
Replies: 22
Views: 696
Posted By 911monty
Fun facts.....

Fun facts.....
Forum: DIY Project Guides 02-17-2021, 01:08 PM
Replies: 22
Views: 696
Posted By 911monty
See the First Law of Thermodynamics (Law of...

See the First Law of Thermodynamics (Law of Conservation of Energy) and Boyle's Law.
Forum: DIY Project Guides 02-15-2021, 06:44 PM
Replies: 22
Views: 696
Posted By 911monty
Wow. I like the KISS principle. Real world...

Wow. I like the KISS principle. Real world example, a centrifugal pump or compressor works by taking a fluid and increasing it's velocity (impeller) then routing to a volute (fancy name for wide part...
Showing results 1 to 25 of 150
Page 1 of 6 1 2 3 Last »

 
Forum Jump


All times are GMT -8. The time now is 06:20 AM.

Contact Us - Pelican Parts Porsche Catalog - Archive - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page