Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums

Showing results 1 to 25 of 33
Search took 0.01 seconds.
Search: Posts Made By: Jojo
Forum: Performance and Technical Chat 10-04-2017, 01:00 PM
Replies: 6
Views: 1,024
Posted By Jojo
Yes since you shall cut to size accordingly. ...

Yes since you shall cut to size accordingly.

Jojo
Forum: Performance and Technical Chat 10-04-2017, 09:42 AM
Replies: 6
Views: 1,024
Posted By Jojo
Hi I replaced one about a year ago and all...

Hi

I replaced one about a year ago and all went well and seems to still be running good. Be extra careful to keep the process clean when installing.

Enter this number in the eBay search field:...
Forum: Boxster General Discussions 06-01-2017, 12:30 PM
Replies: 6
Views: 849
Posted By Jojo
Smile I once had this issue. I dismantled the starter...

I once had this issue. I dismantled the starter and noticed that the grease was old and became gummy. Did a good clean and put new fresh grease, problem solved. It used to do it mostly in winter when...
Forum: Boxster General Discussions 03-03-2017, 07:43 PM
Replies: 4
Views: 1,264
Posted By Jojo
Wink I had the same issue. So I made a rod which I...

I had the same issue. So I made a rod which I manually push and pull with the door open (RHD). At least it makes my mind at rest.
Forum: Boxster General Discussions 01-11-2017, 10:13 AM
Replies: 22
Views: 3,816
Posted By Jojo
update: So I have today received my new...

update:

So I have today received my new Crankshaft sensor (Bosch). When I took off the old sensor I noticed that on the tip on the sensor was a small pile of iron filings, black in colour. I would...
Forum: Boxster General Discussions 01-02-2017, 07:13 AM
Replies: 8
Views: 1,427
Posted By Jojo
Yes I have a ScangaugeII which shows me P0335....

Yes I have a ScangaugeII which shows me P0335. Funnily enough, the car started with the CPS disconnected, however it did take some extra cranking, but did not wait till the engine is warmed up to see...
Forum: Boxster General Discussions 01-02-2017, 04:11 AM
Replies: 22
Views: 3,816
Posted By Jojo
Ok and thanks. Will physically check. ...

Ok and thanks.

Will physically check.

however maybe someone can tell me what ohm meter readings I should read and also the pin numbers of the sensor?

Thanks,
Forum: Boxster General Discussions 01-02-2017, 03:58 AM
Replies: 8
Views: 1,427
Posted By Jojo
Cranks shaft position sensor wiring schematic/ohm readings

Hi,

I'm trying to configure whether I have a faulty CPS.

Maybe someone can tell me what ohm meter readings I should read and also the pin numbers of the sensor?

Thanks,
Forum: Boxster General Discussions 12-31-2016, 07:15 AM
Replies: 22
Views: 3,816
Posted By Jojo
Hi Anker, thanks for your thoughts and I do see...

Hi Anker, thanks for your thoughts and I do see what you explain. Today I reconnected the ScanGauge II and managed to see a P0335 code!. Checked on the forums and found that its the Crank or camshaft...
Forum: Boxster General Discussions 12-26-2016, 06:49 AM
Replies: 22
Views: 3,816
Posted By Jojo
Hi Thanks for your reply, again. Ok so...

Hi

Thanks for your reply, again.

Ok so did some further investigation hoping to eliminate some of the possibilities:

Noticed that at idle sometimes engine stalls as idle is sometimes hunting...
Forum: Boxster General Discussions 12-26-2016, 05:19 AM
Replies: 22
Views: 3,816
Posted By Jojo
Hi thanks for your thoughts, however I am not...

Hi thanks for your thoughts, however I am not sure about what you say since the hesitation only starts when the engine is warmed up.

I also noticed that hesitation is present even when no load,...
Forum: Boxster General Discussions 12-26-2016, 03:31 AM
Replies: 22
Views: 3,816
Posted By Jojo
Hi so I cleaned the MAF and went for a ride,...

Hi so I cleaned the MAF and went for a ride, seems all fine for a while. Then parked car and came back about an hour after, when I came to start the engine I noticed that it took a few more than...
Forum: Boxster General Discussions 12-01-2016, 07:27 PM
Replies: 22
Views: 3,816
Posted By Jojo
So a bad or dirty MAF could work fine on a cold...

So a bad or dirty MAF could work fine on a cold engine and give wrong readings when engine is warm? Resulting to the symptoms that I have and also what you have experienced??
Forum: Boxster General Discussions 12-01-2016, 11:21 AM
Replies: 22
Views: 3,816
Posted By Jojo
No it seems that it hesitates from say 4k...

No it seems that it hesitates from say 4k upwards. To me it looks like misfiring. I'll try to see if I have any codes, but not sure since no engine warning came on yet!

JJ
Forum: Boxster General Discussions 12-01-2016, 12:58 AM
Replies: 22
Views: 3,816
Posted By Jojo
Thanks for the reply. Yes agreed not to over rev...

Thanks for the reply. Yes agreed not to over rev it when still cold, but had to try this out to try configure what's happening....

Cheers

Jojo
Forum: Boxster General Discussions 11-30-2016, 10:55 PM
Replies: 22
Views: 3,816
Posted By Jojo
Hesitation at 4k and over when warm

Hi,

So I started my (cold) 2004 Boxster S without any issues, normal turn of the key and engine fired normally. If I foot the gas, the engine revs up to wherever I press up to full rev counter.
...
Forum: Performance and Technical Chat 11-12-2015, 09:23 AM
Replies: 4
Views: 2,269
Posted By Jojo
I am not sure whether there is any possible way...

I am not sure whether there is any possible way to re synchronize the key with the car. One has to bear in mind, that with the working FOB the led blinks fast even when the key is out of range with...
Forum: Performance and Technical Chat 11-08-2015, 10:09 AM
Replies: 4
Views: 2,269
Posted By Jojo
Smile Key FOB problem- common?

Hi all, so I came out of my 2003 Boxster S and needed to open again the car with the key fob, but the remote will not respond, and noticed that the red LED was flashing slowly, as in once per second...
Forum: Boxster General Discussions 02-17-2015, 12:36 PM
Replies: 110
Views: 11,451
Posted By Jojo
Wink Machine Head by DEEP PURPLE!!

Machine Head by DEEP PURPLE!!
Forum: Boxster General Discussions 02-12-2015, 03:25 AM
Replies: 6
Views: 1,871
Posted By Jojo
Hi thanks for your reply, however the link you...

Hi thanks for your reply, however the link you sent me is for a 3 button fob like the one I presently have. I am looking for the flip type, i.e. the metal part of the key folds into the plastic case...
Forum: Boxster General Discussions 02-11-2015, 09:29 PM
Replies: 6
Views: 1,871
Posted By Jojo
Flip Key Boxster S 2003

Hi,
I am trying to source a flip key shell that can accommodate a 3 button fob for my 2003 Boxster S. I tried eBay and some other major Porsche suppliers but to no avail.

Any ideas would be...
Forum: Boxster General Discussions 09-19-2012, 07:50 AM
Replies: 39
Views: 12,334
Posted By Jojo
Guys, thanks for your various views. The fact...

Guys, thanks for your various views. The fact that today's choice includes a silver car with a red top, means something- to me at least. And by the way, my interior is a full leather Boxster Red with...
Forum: Boxster General Discussions 09-17-2012, 10:52 AM
Replies: 39
Views: 12,334
Posted By Jojo
Red soft top for 2003 Boxster S ?

Hi All, been wondering and surfing in trying to find suppliers for a RED soft top for my 2003 Boxster S. Any ideas?
Thanks
Jojo
Forum: Boxster General Discussions 09-01-2012, 12:38 PM
Replies: 4
Views: 1,543
Posted By Jojo
hi again. So now it is becoming more confusing...

hi again. So now it is becoming more confusing for me :( I went to check about the horn next to the battery, and can see that in fact there is one and it was unplugged!!. I plugged it and the alarm...
Forum: Boxster General Discussions 09-01-2012, 12:03 PM
Replies: 4
Views: 1,543
Posted By Jojo
Thanks for your replies. In Europe it seems that...

Thanks for your replies. In Europe it seems that the alarm system is one of the things that are different in Boxsters to the USA versions. Yes the alarm is a separate box, next to the battery. It...
Showing results 1 to 25 of 33

 
Forum Jump


All times are GMT -8. The time now is 05:13 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page