986 Forum - The Community for Porsche Boxster & Cayman Owners

		986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums
Search Results

Garage

Showing results 1 to 13 of 13
Search took 0.01 seconds. Search: Posts Made By: tradergarry

Forum: Boxster General Discussions

05-23-2015, 09:45 PM

Replies: 9

Clutch Bleeding

Views: 2,088

Posted By tradergarry

slave cylinder

Does anyone have a diagram as to how the slave components can be reassembled after coming apart (new slave). I don't see any type of snap ring or keeper.

Forum: Boxster General Discussions

05-23-2015, 11:18 AM

Replies: 9

Clutch Bleeding

Views: 2,088

Posted By tradergarry

Clutch Bleeding

Hi Everyone:
I replaced clutch slave on 2000 2.7 Boxster. Then pumped pressure to 22 psi. with clutch pedal to floor. Let air out of bleeder valve. Pulled clutch up by hand. Clutch would not go...

Forum: Boxster General Discussions

11-15-2013, 08:42 AM

Replies: 2

2000 Boxster has rough idle and these codes

Views: 1,049

Posted By tradergarry

Hmm. I replaced my AOS about 2 years ago, but...

Hmm. I replaced my AOS about 2 years ago, but I'll check hoses to and from.
Thanks,
Garry

Forum: Boxster General Discussions

11-13-2013, 05:57 PM

Replies: 2

2000 Boxster has rough idle and these codes

Views: 1,049

Posted By tradergarry

2000 Boxster has rough idle and these codes

Hi everyone, I'm experiencing a rough idle on my boxster. I hooked up the Durametric and I have the following codes:

P code 174

P code 62

P code 65 cyl 3 misfire

P code 63 cyl 1 misfire

Forum: Performance and Technical Chat

10-02-2013, 10:28 AM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

I installed cps and that did the trick for the...

I installed cps and that did the trick for the starting issue. Now I'm chasing vent line and purge line issues and a rattle near the rear axle. I know its not struts or mounts, sway bar bushings or...

Forum: Performance and Technical Chat

09-17-2013, 10:27 AM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

I've ordered a crank position sensor. Can...

I've ordered a crank position sensor. Can someone tell me where the other end of the purge line goes, the one that is under the left side intake. I assume it goes to either the fuel tank or the...

Forum: Performance and Technical Chat

08-31-2013, 07:45 PM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

Thanks guys. Didn't get to tinker w the car...

Thanks guys. Didn't get to tinker w the car today, I'll keep ya posted.

Forum: Performance and Technical Chat

08-30-2013, 08:00 PM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

cranks wont start

Today I pulled the immobilizer, cleaned with electronics cleaner, checked wires, fuse, and solder joints under magnification. Replaced. Same thing. Since I cleared the codes, immobilizer, and...

Forum: Performance and Technical Chat

08-27-2013, 08:09 PM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

It will start when cold only. Last night I...

It will start when cold only. Last night I started it, cleared the codes, and let it run till it died: about 15 min. warmed up to 180 degrees then died abruptly. Then an immobilizer failure code...

Forum: Performance and Technical Chat

08-25-2013, 07:58 PM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

I think it's consistently been a hot start. Once...

I think it's consistently been a hot start. Once it died at a red light and would not restart. Second time after replacing relay, it was a hot start failure.

Forum: Performance and Technical Chat

08-23-2013, 04:23 PM

Replies: 10

Starting issue. Cranks-no start

Views: 3,599

Posted By tradergarry

Starting issue. Cranks-no start

Hi, I could use some help. My Boxster left me stranded at a light. Would crank but not start. After checking fuel pump fuse was ok I had it towed home. I jumpered pins 30 and 87 on fuel pump...

Forum: Boxster General Discussions

05-18-2012, 03:06 PM

Replies: 25

update on overheating- now what?

Views: 4,498

Posted By tradergarry

Has anyone replaced the low speed fan resistors...

Has anyone replaced the low speed fan resistors with radioshack ones? If so I would love to have the specs or part #. Resistors are $80 from Porsche and I need both a piece and I need both. Just...

Forum: Boxster General Discussions

01-23-2011, 07:05 PM

Replies: 1

cracked green injector tip

Views: 1,091

Posted By tradergarry

cracked green injector tip

Hi I'm new here, with a new to me 2000 Boxster. I've always done my own repairs. Mostly I've been fixing oil leaks. on this one. I removed the rt. side intake while replacing damaged plastic oil...

Showing results 1 to 13 of 13

All times are GMT -8. The time now is 02:04 AM.