Clutch Alignment Tool
 

Replacing the clutch in my 00 Boxster after 228,000Km.

In the past I have used a home made tool that I made from a broom handle, but want to ensure I get it right 1st time as it looks like a PITA to the the trans back in.

Any hints or idea's would be appreciated.

Clutch kit should come with one...

If not, a big wooden dowel with the end turned down to fit the pilot bearing might work.

If your car is a 5-spd, send me your address, I'll send you the tool. (The 5 spd is a different diameter input shaft than the 6 spd. Ask me how I know.... grrr)

Sent from my SM-G930T using Tapatalk

They are $9
https://www.pelicanparts.com/catalog/SuperCat/1046/POR_1046_TCLUTC_pg2.htm#item11

Yes it's a 5 speed but I'm in Australia

Which one is for the Boxster & which for the Boxster S?


Clutch Alignment Tool,, (Spline count = 23; Pilot diameter = 14.9 mm; Spline diameter = 23.8 mm)


Clutch Alignment Tool,, (Spline count = 23; Pilot diameter = 14.9 mm; Spline diameter = 25.4 mm)

The larger diameter is the S. (I didn't measure it, so can't confirm the 25.4mm, but the clutch tool for the 5-spd fits snugly in the 5-spd clutch, whereas it's all loosey-goosey in the 6-spd clutch. )

Sent from my SM-G930T using Tapatalk

Thanks mate