Durametric Litronic Faults
My car has OEM Litronics. 03S. Using Durametric I can move them center/up/down
The headlights come on and go to hi beams Durametric comes up with the following faults (the actual fault numbers are 1,2,3,4,5,6) 1. Engine Path Left 2. Engine Path Right 3. Axle Position Sensor – Front 4. Axle Position Sensor – Rear 5. 5v Supply Axle Position Sensors 6. Control Unit Coding Error Is there something I should do? Thanks Bob |
Quote:
|
Thanks...I will check it out then.
|
1 Attachment(s)
So..I found a plug that was disconnected from the right side light...plugged it back in and ran Durametric.
Error 5 & 6 are gone but 1.2.3.4 are still active. Anything ele I can (should) do? Thanks again Bob |
Looking a little further I found the bracket that holds the little lever on the suspension broken. I have ordered it (actually 2 in case the rear is also damaged) so I hope that wraps up my Litronics adventure.
|
All times are GMT -8. The time now is 08:07 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website