Strange CEL p 1671
I recently got a CEL and the code came back as 1671. Anybody ever dealt with this one? I looked it up and came up with two possibilities: ECU fault or engine compartment fan. There has been no change in the way the car runs.
|
can you see if you can activate the engine compartment fan with your durametric? good way to test to see if it is working ..
|
From the 7.8 DME Manual:
P1671 DME relay/control module faulty (computer monitoring: reset) – signal implausible Possible fault cause ◆ Undervoltage ◆ DME relay faulty ◆ DME control module faulty This fault may be entered if the control module has been operated with undervoltage. Affected terminals I/1 and I/8 Diagnosis/troubleshooting Note! • If no fault is present, erase the fault memory. 1) Check voltage supply, terminal 15 ◆ Measure voltage between pin I/1 and ground. > 11 V 2) Check DME relay ◆ Switch on the ignition ◆ Measure voltage between pin I/18 and ground Battery positive voltage Check triggering of DME relay Replace DME relay 3) Replace DME control module. 4) Perform adaptation. ◆ Switch on the ignition ◆ Wait one minute ◆ Do not press the accelerator ◆ Switch off the ignition for at least 10 seconds ◆ Read out the fault memory -> End -> End |
Hi, a have this same problem with fault 1671 and my car is not interested to start :) Do you solved your problem?
|
All times are GMT -8. The time now is 12:09 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website