Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Performance and Technical Chat

Post Reply
 
LinkBack Thread Tools Display Modes
Old 01-08-2006, 11:36 PM   #1
Registered User
 
Join Date: Sep 2005
Location: Sacramento
Posts: 3,417
Send a message via AIM to blinkwatt
Check Engine Light Came On!

I was coming home from a friends house and started the car up,with no problems. Drove for a couple of minutes till I looked to see how fast I was going,and to my surprise I found the check engine light on(could have possibly been on from when I fired it up,I wasnt paying too much attention). The car drove fine,no hesitation,odd sounds etc. As soon as I noticed the light I consulted with a friend who has a Boxster and he said it could be my MAF. Makes sense,I have a K & N Air Filter. It has been on since 46k I beleive,no reoiling etc. No other modifications have been made mechanically. Just looking for some input on what you think it could be. If I remember correctly is there a tool,I think its a OBD II reader, I can use at a Autozone to check the code?
__________________
-99' Zenith Blue 5-spd...didn't agree with a center divider on the freeway
-01' S Orient Red Metallic 6-spd...money pit...sold to buy a house
blinkwatt is offline   Reply With Quote
Old 01-09-2006, 02:57 PM   #2
Registered User
 
Join Date: Feb 2005
Location: Chicago
Posts: 283
Get the code read...guessing is futile! Even after having the code read you may end up going the wrong direction since problems in one part of the emissions system may cause other parts to overcompensate... and set a code concerning the incorrect part (O2, MAF, etc...)
__________________
2000 Porsche Boxster S
2007 Lexus RX350
xclusivecar is offline   Reply With Quote
Old 01-09-2006, 04:06 PM   #3
Registered User
 
Join Date: Aug 2005
Location: Overland Park, KS
Posts: 180
The code reader may give you a MAF code, or it may give you oxygen sensor codes on bank 1 AND bank 2 or a combination of both the MAF and O2 (bank1/2). If it gives both banks, then it is likely the MAF sensor gone bad, and you can ignore the o2 sensor codes. If it gives no maf code, and just an O2 sensor on bank 1 OR bank 2 then the culprit is a bad o2 sensor on that side (you will replace both pre and post o2 sensors on that one side if this is the case).

I am suprised the K&N hasn't blown the MAF sooner, it seems to be the trend.
__________________
Karl Wilen
RennsportKC
PorscheDoc is offline   Reply With Quote
Old 01-09-2006, 10:50 PM   #4
Registered User
 
Join Date: Sep 2005
Location: Sacramento
Posts: 3,417
Send a message via AIM to blinkwatt
I will be stopping at the local Autozone tommorow to barrow their OBD II reader. I notice today when I was driving that the idling was off just a tiny bit and that when I went to give it gas half the time it was if the car lost 50 ponies. But at other times it was fine. What could I use to clean the MAF if that is the culprit.
__________________
-99' Zenith Blue 5-spd...didn't agree with a center divider on the freeway
-01' S Orient Red Metallic 6-spd...money pit...sold to buy a house
blinkwatt is offline   Reply With Quote
Old 01-10-2006, 04:30 AM   #5
Registered User
 
Join Date: Aug 2005
Location: Overland Park, KS
Posts: 180
We have tried the recommended electronics cleaner (i can't remember what it was called, you poured it in a cup, soaked the sensor for 20 minutes and that was that.....can't seem to locate the bottle at the moment), but it proved to be a short term fix only. Proper thing to do is to replace the sensor if it is bad.
__________________
Karl Wilen
RennsportKC
PorscheDoc is offline   Reply With Quote
Old 01-10-2006, 10:03 AM   #6
Registered User
 
Perfectlap's Avatar
 
Join Date: Nov 2004
Location: New Jersey
Posts: 8,709
The only time the CEL came on was when the gas station dude didn't screw the cap on right.
They'll read the CEL code for you at Jiffy Lube as well as at AutoZone.
__________________
GT3 Recaro Seats - Boxster Red
GT3 Aero / Carrera 18" 5 spoke / Potenza RE-11
Fabspeed Headers & Noise Maker
BORN: March 2000 - FINLAND
IMS#1 REPLACED: April 2010 - NEW JERSEY -- LNE DUAL ROW
Perfectlap is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 11:37 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page