![]() |
engine case bolts
hi guys.
about to start my clutch,IMSB,RMS... in the Bentley book, it say to replace 4 bolts that connects the 2 parts of the engine case, when doing the RMS job. this picture shows 3 of the 4 bolts mentioned in the Bentley book: http://986forum.com/forums/uploads01...1354719993.jpg i guess its one of the "while you in there" type of thing. however, i didn't see any reference to that on Wayne's article, or anywhere else for that matter. is that necessary? or is it an overkill? also what is the green stuff on the IMS cover stud? thanks. Meir. |
The 4th bolt is above the RMS. I would only replace them if they are leaking. The green stuff on the IMS is probably Curil T & is good for the same purpose on the new IMSB.
|
Quote:
that is what i was hoping to hear. |
All times are GMT -8. The time now is 02:45 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website