Variocam wire on 3.4 swap
 

Hi
I have another question about 3.4(99') swap in to my 99' box

I've been searching but no luck

How do I make the variocam work?
I know I should run wire from VC to computer but that's all
Is there wire I need to buy or I'm using existing wires
Where shoud I connect it in the harness?
Lookin for detailed explanation
Any pics???

Please help that's the last thing that holding this swap

Best regards

Anybody with the swap????

Well.....
I have Raby rebuilt 2002 3.8 X51 VCAM+ in a 99 996 chassis.
There should be 2 solenoids one on each side of your engine the trigger the switchover.
Mine uses a MSD 8969 RPM window switch to turn on and off the VCAM.
Its triggered by the RPM lead at the ECU, on at 3200 off at 6500.
When triggered, it grounds a relay connected to the VCAM solenoids.
It does not use the full infinite adjustment ability in the + system, but I don't care. Its a track car that spends most of its time at RPM from 5 to 7.5k.
The conversion was done in in 2004. It ran over 9k miles before the crank became a 2 piece.
It now has over 3k on the rebuild and is running fantastic.