Error code 1341 DTC 174
 

I went to the track this weekend and this code came up. Durametric readout says "cam adjustment bank 1 below limit". I did get some range 1 over-revs, but no range 2 over-revs. Cam deviations were steady after taking readings throughout the day.

What does the code mean and is there anything to worry about?

some info on P1341
 

Fault conditions:
(1) No triggering of the actuator, active position
nevertheless.
-- Short to ground
-- Actuator is faulty

(2) Triggering of the actuator, no active position
-- Open circuit in triggering wire
-- Open circuit in B+ supply
-- Actuator faulty

(3) No active or passive position is detected
-- Actuator faulty


If you're tempted to troubleshoot this issue, send me a PM with your email.

Regards,
paul...