snap on tools call them ..triple square...some people use SAE allens in a pinch

Can I buy this tool at a hardware store? :confused:

Stop searching and posting and start cutting! :cheers:

maybe, i dont know. imo...you are into some HD work and will be using a torque wrench...el cheapo bits will break,flex,round out etc.....think sears at the bottom and snap on at the top. porsche seems to use the triple square [what were they thinking] and you will be working on the car alot.....go snap on

Got the trany out!! the little odd bolt was a 1w point torx wrench
 

<a href="http://tinypic.com" target="_blank"><img src="http://i40.tinypic.com/1z5s1sh.jpg" border="0" alt="Image and video hosting by TinyPic"></a>
<br /><br />here are all the suckers<br /><br />
took these out because they were bugin me<br />
<a href="http://tinypic.com" target="_blank"><img src="http://i42.tinypic.com/9roi6s.jpg" border="0" alt="Image and video hosting by TinyPic"></a>
<br /><br />
<a href="http://tinypic.com" target="_blank"><img src="http://i41.tinypic.com/1ta443.jpg" border="0" alt="Image and video hosting by TinyPic"></a><br /><br />
It's out!!<br /><br />
<a href="http://tinypic.com" target="_blank"><img src="http://i39.tinypic.com/23uo16u.jpg" border="0" alt="Image and video hosting by TinyPic"></a><br /><br />
there's the lonesome engine now...So after this whats next haha, let me rephrase that. The engine can move with my hand, whats holding it? just the motor mount in the back? :cheers:

Shoulda took it all out as one. I think it is easier that way. Just the front motor mount, coolant, fuel and dme harness and you should be set... Throttle cable and other little doo dads but your just about there. I used a motor cycle jack to get mine out. It fits under the motor perfectly.. Good luck.