Radio Installation
 

Okay,
I just got my Becker aux input for a CDR-220. I took the radio out and plugged the piece in. I have everything set up except I cannot get the stereo back in. I read that I need to pull the wiring from behind. How do I do this?
Thanks!

Also, does anyone know the radio code for the cdr-220?

I have the serial number: X5012739
Can anyone decode it?
Thanks!

Hi, I removed my radio and re-installed it with no problems, just be sure that the antenna and other wires are not in the way when pushing it back in, and remove the 2 keys you used to pull it out before pushing it back in place.

For the radio code you must call a Porsche dealer and give them the VIN # of the car that the original radio came with. That is what i did and got the code in 10 minutes, no charge. I don't think the serial # on the radio will get you the code, that would be a joke for thieves don"t you think :D

Good Luck :)

I finally got it.
The becker ipod aux input normally takes about an hour it took my 5 hours. But I
got it done. I finally removed the a/c and had no trouble outting the radio back in.
And the a nice member of renntech got me my radio code.